[PATCH 5/7] DONOTMERGE: arm64: dts: ti: k3-am642-sk: Enable PRU UART

[Judith Mendez]

There is one PRU UART module in each ICSSG for am64 SoC.

UART RX/TX signals for PRU UART in ICSSG0 can be routed from/to the
PRU Connector J10 (pins 45/44) on am64x SK, so enable icssg0_uart by
default and add pinmux node.

Signed-off-by: Judith Mendez <jm at ti.com>
---
 arch/arm64/boot/dts/ti/k3-am642-sk.dts | 16 ++++++++++++++++
 1 file changed, 16 insertions(+)

diff --git a/arch/arm64/boot/dts/ti/k3-am642-sk.dts b/arch/arm64/boot/dts/ti/k3-am642-sk.dts
index 1deaa0be0085..9065fc8a7569 100644
--- a/arch/arm64/boot/dts/ti/k3-am642-sk.dts
+++ b/arch/arm64/boot/dts/ti/k3-am642-sk.dts
@@ -25,6 +25,7 @@ aliases {
 		serial0 = &mcu_uart0;
 		serial1 = &main_uart1;
 		serial2 = &main_uart0;
+		serial3 = &icssg0_uart;
 		i2c0 = &main_i2c0;
 		i2c1 = &main_i2c1;
 		mmc0 = &sdhci0;
@@ -284,6 +285,15 @@ AM64X_IOPAD(0x0244, PIN_OUTPUT, 0) /* (E14) UART1_TXD */
 		>;
 	};
 
+	icssg0_uart_pins_default: icssg0-uart-default-pins {
+		pinctrl-single,pins = <
+			AM64X_IOPAD(0x0184, PIN_INPUT, 2) /* (W6) PRG0_PRU0_GPO9.PRG0_UART0_CTSn */
+			AM64X_IOPAD(0x0188, PIN_OUTPUT, 2) /* (AA5) PRG0_PRU0_GPO10.PRG0_UART0_RTSn */
+			AM64X_IOPAD(0x01d4, PIN_INPUT, 2) /* (Y5) PRG0_PRU1_GPO9.PRG0_UART0_RXD */
+			AM64X_IOPAD(0x01d8, PIN_OUTPUT, 2) /* (V6) PRG0_PRU1_GPO10.PRG0_UART0_TXD */
+		>;
+	};
+
 	main_usb0_pins_default: main-usb0-default-pins {
 		bootph-all;
 		pinctrl-single,pins = <
@@ -413,6 +423,12 @@ &main_uart1 {
 	pinctrl-0 = <&main_uart1_pins_default>;
 };
 
+&icssg0_uart {
+	pinctrl-names = "default";
+	pinctrl-0 = <&icssg0_uart_pins_default>;
+	status = "okay";
+};
+
 &main_i2c0 {
 	bootph-all;
 	status = "okay";
-- 
2.49.0