[PATCH 12/14] dt-bindings: spi: dspi: Add S32G support

[James Clark]

On 09/05/2025 12:14 pm, Krzysztof Kozlowski wrote:
> On 09/05/2025 13:05, James Clark wrote:
>> From: Ciprian Marian Costea <ciprianmarian.costea at nxp.com>
>>
>> Document S32G compatible strings. 's32g2' and 's32g3' use the same
>> driver so 's32g2' must follow 's32g3'.
>>
>> The SPI controller node in dts can define both host and target pinctrl.
>> The selection between them will be done based on pinctrl-names. The
>> default pinctrl will be loaded first and will be used by the host. If
>> the controller is configured as target (spi-slave property is added in
>> the dts node), the driver will look for the "slave" pinctrl and apply it
>> if found.
> 
> 
> I do not see any changes in the binding related to above paragraph, so I
> do not understand why are you explaining driver?
> 

Yes it's probably a bit verbose, it's just a standard SPI binding that 
also supports target mode. I can reduce it.

I'm also not even sure the "slave" pinctrl part is correct as I was 
testing it in target mode without any special naming. I will double 
check that too.

>>
>> Signed-off-by: Ciprian Marian Costea <ciprianmarian.costea at nxp.com>
>> Signed-off-by: Larisa Grigore <larisa.grigore at nxp.com>
>> Signed-off-by: James Clark <james.clark at linaro.org>
>> ---
>>   Documentation/devicetree/bindings/spi/fsl,dspi.yaml | 18 ++++++++++++++++++
>>   1 file changed, 18 insertions(+)
>>
>> diff --git a/Documentation/devicetree/bindings/spi/fsl,dspi.yaml b/Documentation/devicetree/bindings/spi/fsl,dspi.yaml
>> index 7ca8fceda717..b5fac0bb142a 100644
>> --- a/Documentation/devicetree/bindings/spi/fsl,dspi.yaml
>> +++ b/Documentation/devicetree/bindings/spi/fsl,dspi.yaml
>> @@ -23,6 +23,7 @@ properties:
>>             - fsl,ls2080a-dspi
>>             - fsl,ls2085a-dspi
>>             - fsl,lx2160a-dspi
>> +          - nxp,s32g2-dspi
>>         - items:
>>             - enum:
>>                 - fsl,ls1012a-dspi
>> @@ -37,6 +38,9 @@ properties:
>>         - items:
>>             - const: fsl,lx2160a-dspi
>>             - const: fsl,ls2085a-dspi
>> +      - items:
>> +          - const: nxp,s32g3-dspi
>> +          - const: nxp,s32g2-dspi
>>   
>>     reg:
>>       maxItems: 1
>> @@ -114,3 +118,17 @@ examples:
>>                   spi-cs-hold-delay-ns = <50>;
>>           };
>>       };
>> +  # S32G3 in target mode
>> +  - |
>> +    spi0: spi at 401d4000 {
> 
> Drop unused label.
> 

Will do.

> 
> Reviewed-by: Krzysztof Kozlowski <krzysztof.kozlowski at linaro.org>
> 
> Best regards,
> Krzysztof

Thanks for the review.

James