[PATCH 07/14] spi: spi-fsl-dspi: Reset SR flags before sending a new message

[James Clark]

From: Larisa Grigore <larisa.grigore at nxp.com>

If, in a previous transfer, the controller sends more data than expected
by the DSPI target, SR.RFDF (RX FIFO is not empty) will remain asserted.
When flushing the FIFOs at the beginning of a new transfer (writing 1
into MCR.CLR_TXF and MCR.CLR_RXF), SR.RFDF should also be cleared.
Otherwise, when running in target mode with DMA, if SR.RFDF remains
asserted, the DMA callback will be fired before the controller sends any
data.

Take this opportunity to reset all Status Register fields. This is
required for enabling target mode for S32G in a later commit.

Signed-off-by: Larisa Grigore <larisa.grigore at nxp.com>
Signed-off-by: James Clark <james.clark at linaro.org>
---
 drivers/spi/spi-fsl-dspi.c | 2 ++
 1 file changed, 2 insertions(+)

diff --git a/drivers/spi/spi-fsl-dspi.c b/drivers/spi/spi-fsl-dspi.c
index 902bf23d276a..b7363cfc649d 100644
--- a/drivers/spi/spi-fsl-dspi.c
+++ b/drivers/spi/spi-fsl-dspi.c
@@ -1063,6 +1063,8 @@ static int dspi_transfer_one_message(struct spi_controller *ctlr,
 				   SPI_MCR_CLR_TXF | SPI_MCR_CLR_RXF,
 				   SPI_MCR_CLR_TXF | SPI_MCR_CLR_RXF);
 
+		regmap_write(dspi->regmap, SPI_SR, SPI_SR_CLEAR);
+
 		spi_take_timestamp_pre(dspi->ctlr, dspi->cur_transfer,
 				       dspi->progress, !dspi->irq);
 

-- 
2.34.1