[PATCH 5/8] PCI: rzg3s-host: Add Initial PCIe Host Driver for Renesas RZ/G3S SoC

[Claudiu Beznea]

Hi, Bjorn,

On 05.05.2025 14:26, Claudiu Beznea wrote:
> Hi, Bjorn,
> 
> On 01.05.2025 23:12, Bjorn Helgaas wrote:
>> On Wed, Apr 30, 2025 at 01:32:33PM +0300, Claudiu wrote:
>>> From: Claudiu Beznea <claudiu.beznea.uj at bp.renesas.com>
>>>
>>> The Renesas RZ/G3S features a PCIe IP that complies with the PCI Express
>>> Base Specification 4.0 and supports speeds of up to 5 GT/s. It functions
>>> only as a root complex, with a single-lane (x1) configuration. The
>>> controller includes Type 1 configuration registers, as well as IP
>>> specific registers (called AXI registers) required for various adjustments.
>>>
>>> Other Renesas RZ SoCs (e.g., RZ/G3E, RZ/V2H) share the same AXI registers
>>> but have both Root Complex and Endpoint capabilities. As a result, the PCIe
>>> host driver can be reused for these variants with minimal adjustments.
>>
>> I guess this current driver only supports RZ/GS3 in Root Complex mode?
> 
> That's right.
> 
>> If so, I don't think this paragraph is necessary or really relevant.
> 
> OK, I'll drop it.
> 
>>
>>> +++ b/drivers/pci/controller/pcie-rzg3s-host.c
>>> @@ -0,0 +1,1561 @@
>>
>> I can't figure out the line width you're using.  Generally code in
>> drivers/pci/ is formatted to fit in 80 columns.  Much of this file is
>> formatted for that, but there are many cases that seem to use 90 or
>> 100 columns.
> 
> I formated it at 100 columns where the lines were longer. I wasn't aware
> the PCI rule is to have line formated at 80 columns. I'll switch to it in
> the next version.
> 
>>
>> For single-line comments that are not a sentence or are a single
>> sentence, it's typical to omit the period at end.
> 
> I'll follow this rule, too.
> 
>>
>>> +static void rzg3s_pcie_update_bits(void __iomem *base, u32 offset, u32 mask, u32 val)
>>> +{
>>> +	u32 tmp;
>>> +
>>> +	tmp = readl(base + offset);
>>> +	tmp &= ~mask;
>>> +	tmp |= val & mask;
>>> +	writel(tmp, base + offset);
>>> +}
>>
>> Nothing rzg3s-specific here.
>>
>> I think u32p_replace_bits() (include/linux/bitfield.h) is basically this.
> 
> I wasn't aware of it. I'll use it in the next version. Thank for pointing it.

I look into changing to u32p_replace_bits() but this one needs a mask that
can be verified at build time. It cannot be used directly in this function.
Would you prefer me to replace all the calls to rzg3s_pcie_update_bits() with:

tmp = readl();
u32p_replace_bits(&tmp, ...)
writel(tmp);

or is it OK for you to keep it as is?

Thank you,
Claudiu