[PATCH 1/2] dt-bindings: fpga: zynq: Document ICAP on boot

[Sam Winchenbach]

From: Sam Winchenbach <swinchenbach at arka.org>

Documents the ability to enable the ICAP interface on boot.

Signed-off-by: Sam Winchenbach <swinchenbach at arka.org>
---
 .../devicetree/bindings/fpga/xilinx-zynq-fpga-mgr.yaml     | 7 +++++++
 1 file changed, 7 insertions(+)

diff --git a/Documentation/devicetree/bindings/fpga/xilinx-zynq-fpga-mgr.yaml b/Documentation/devicetree/bindings/fpga/xilinx-zynq-fpga-mgr.yaml
index 04dcadc2c20e9..bb2781ae126ca 100644
--- a/Documentation/devicetree/bindings/fpga/xilinx-zynq-fpga-mgr.yaml
+++ b/Documentation/devicetree/bindings/fpga/xilinx-zynq-fpga-mgr.yaml
@@ -31,6 +31,13 @@ properties:
     description:
       Phandle to syscon block which provide access to SLCR registers
 
+  enable-icap-on-load:
+    type: boolean
+    description: If present, the ICAP controller will be enabled when
+      the driver probes. This is useful if the fabric is loaded
+      during the boot process and contains a core, such as the SEM,
+      that requires access to ICAP interface to operate properly.
+
 required:
   - compatible
   - reg
-- 
2.49.0