[PATCH] arm64: dts: rockchip: Improve gmac phy setup for QNAP-TS433

[Uwe Kleine-König]

Instead of relying on the MDIO broadcast address (0) talk to the phy on
its configured address. Also add the phy reset gpio which was found by
Heiko inspecting the U-Boot vendor source code. He is still trying to
recover.

Signed-off-by: Uwe Kleine-König <uwe at kleine-koenig.org>
---
 .../arm64/boot/dts/rockchip/rk3568-qnap-ts433.dts | 15 +++++++++++++--
 1 file changed, 13 insertions(+), 2 deletions(-)

diff --git a/arch/arm64/boot/dts/rockchip/rk3568-qnap-ts433.dts b/arch/arm64/boot/dts/rockchip/rk3568-qnap-ts433.dts
index 7bd32d230ad2..411f8ac7994b 100644
--- a/arch/arm64/boot/dts/rockchip/rk3568-qnap-ts433.dts
+++ b/arch/arm64/boot/dts/rockchip/rk3568-qnap-ts433.dts
@@ -481,9 +481,14 @@ eeprom at 56 {
 };
 
 &mdio0 {
-	rgmii_phy0: ethernet-phy at 0 {
+	rgmii_phy0: ethernet-phy at 3 {
+		/* Motorcomm YT8521 phy */
 		compatible = "ethernet-phy-ieee802.3-c22";
-		reg = <0x0>;
+		reg = <0x3>;
+		pinctrl-0 = <&eth_phy0_reset_pin>;
+		pinctrl-names = "default";
+		reset-assert-us = <10000>;
+		reset-gpios = <&gpio0 RK_PC6 GPIO_ACTIVE_LOW>;
 	};
 };
 
@@ -556,6 +561,12 @@ &pcie3x2 {
 };
 
 &pinctrl {
+	gmac0 {
+		eth_phy0_reset_pin: eth-phy0-reset-pin {
+			rockchip,pins = <0 RK_PC6 RK_FUNC_GPIO &pcfg_pull_up>;
+		};
+	};
+
 	keys {
 		copy_button_pin: copy-button-pin {
 			rockchip,pins = <0 RK_PB6 RK_FUNC_GPIO &pcfg_pull_up>;

base-commit: 2014c95afecee3e76ca4a56956a936e23283f05b
-- 
2.47.1