[Upstream] [PATCH v7 3/3] arm64: dts: imx8mm-phyboard-polis-peb-av-10: Set lvds-vod-swing

[Andrej Picej]

Hi,

is there anything else I need to do, or can this patch now be applied?

The initial two patches that introduce property support have already 
been merged, and the patch series that this patch depends on [1] has 
also been applied.

[1] https://lore.kernel.org/all/Z7rZjdXwN2W+Y2Bd@dragon/

Best regards,
Andrej

On 16. 12. 24 09:54, Andrej Picej wrote:
> Set custom differential output voltage for LVDS, to fulfill requirements
> of the connected display. LVDS differential voltage for data-lanes and
> clock output has to be between 200 mV and 600 mV.
> Driver sets 200 Ohm near-end termination by default.
> 
> Signed-off-by: Andrej Picej <andrej.picej at norik.com>
> ---
> Changes in v7:
> - no change
> Changes in v6:
> - no change
> Changes in v5:
> - no change
> Changes in v4:
> - no change
> Changes in v3:
> - no change
> Changes in v2:
> - use new properties from previous patches
> ---
>   .../boot/dts/freescale/imx8mm-phyboard-polis-peb-av-10.dtso     | 2 ++
>   1 file changed, 2 insertions(+)
> 
> diff --git a/arch/arm64/boot/dts/freescale/imx8mm-phyboard-polis-peb-av-10.dtso b/arch/arm64/boot/dts/freescale/imx8mm-phyboard-polis-peb-av-10.dtso
> index a9de42cf14be..8bf9cc553bea 100644
> --- a/arch/arm64/boot/dts/freescale/imx8mm-phyboard-polis-peb-av-10.dtso
> +++ b/arch/arm64/boot/dts/freescale/imx8mm-phyboard-polis-peb-av-10.dtso
> @@ -186,6 +186,8 @@ port at 2 {
>   			reg = <2>;
>   			bridge_out: endpoint {
>   				remote-endpoint = <&panel_in>;
> +				ti,lvds-vod-swing-clock-microvolt = <200000 600000>;
> +				ti,lvds-vod-swing-data-microvolt = <200000 600000>;
>   			};
>   		};
>   	};