[PATCH net-next v2 5/9] net: stmmac: meson8b: remove of_get_phy_mode()

[Russell King (Oracle)]

devm_stmmac_probe_config_dt() already gets the PHY mode from firmware,
which is stored in plat_dat->phy_interface. Therefore, we don't need to
get it in platform code.

Set dwmac->phy_mode from plat_dat->phy_interface.

Reviewed-by: Michal Kubiak <michal.kubiak at intel.com>
Signed-off-by: Russell King (Oracle) <rmk+kernel at armlinux.org.uk>
---
 drivers/net/ethernet/stmicro/stmmac/dwmac-meson8b.c | 6 +-----
 1 file changed, 1 insertion(+), 5 deletions(-)

diff --git a/drivers/net/ethernet/stmicro/stmmac/dwmac-meson8b.c b/drivers/net/ethernet/stmicro/stmmac/dwmac-meson8b.c
index 9c2d62d133ad..a50782994b97 100644
--- a/drivers/net/ethernet/stmicro/stmmac/dwmac-meson8b.c
+++ b/drivers/net/ethernet/stmicro/stmmac/dwmac-meson8b.c
@@ -417,11 +417,7 @@ static int meson8b_dwmac_probe(struct platform_device *pdev)
 		return PTR_ERR(dwmac->regs);
 
 	dwmac->dev = &pdev->dev;
-	ret = of_get_phy_mode(pdev->dev.of_node, &dwmac->phy_mode);
-	if (ret) {
-		dev_err(&pdev->dev, "missing phy-mode property\n");
-		return ret;
-	}
+	dwmac->phy_mode = plat_dat->phy_interface;
 
 	/* use 2ns as fallback since this value was previously hardcoded */
 	if (of_property_read_u32(pdev->dev.of_node, "amlogic,tx-delay-ns",
-- 
2.30.2