[PATCH v2 1/2] phy: freescale: imx8m-pcie: cleanup reset logic

[Frank Li]

On Wed, Mar 05, 2025 at 03:43:15PM +0100, Stefan Eichenberger wrote:
> From: Stefan Eichenberger <stefan.eichenberger at toradex.com>
>
> Remove the switch statement and base perst release on whether it is
> found in the device tree. The probe function fails without the reset
> property, making it mandatory. Therefore, always release reset
> independent of the variant.

Thanks for clean up this.

"Remove the switch statement for releasing 'perst' and 'reset' since they
are already correctly set at probe and are no-ops for
reset_control_deassert(NULL). Call these unconditionally."

Reviewed-by: Frank Li <Frank.Li at nxp.com>

>
> This does not change the behavior of the driver but reduces driver
> complexity and allows for easier future modifications.
>
> Signed-off-by: Stefan Eichenberger <stefan.eichenberger at toradex.com>
> ---
>  drivers/phy/freescale/phy-fsl-imx8m-pcie.c | 12 +++---------
>  1 file changed, 3 insertions(+), 9 deletions(-)
>
> diff --git a/drivers/phy/freescale/phy-fsl-imx8m-pcie.c b/drivers/phy/freescale/phy-fsl-imx8m-pcie.c
> index e98361dcdeadf..5b505e34ca364 100644
> --- a/drivers/phy/freescale/phy-fsl-imx8m-pcie.c
> +++ b/drivers/phy/freescale/phy-fsl-imx8m-pcie.c
> @@ -141,15 +141,9 @@ static int imx8_pcie_phy_power_on(struct phy *phy)
>  			   IMX8MM_GPR_PCIE_REF_CLK_PLL);
>  	usleep_range(100, 200);
>
> -	switch (imx8_phy->drvdata->variant) {
> -	case IMX8MP:
> -		reset_control_deassert(imx8_phy->perst);
> -		fallthrough;
> -	case IMX8MM:
> -		reset_control_deassert(imx8_phy->reset);
> -		usleep_range(200, 500);
> -		break;
> -	}
> +	reset_control_deassert(imx8_phy->perst);
> +	reset_control_deassert(imx8_phy->reset);
> +	usleep_range(200, 500);
>
>  	/* Do the PHY common block reset */
>  	regmap_update_bits(imx8_phy->iomuxc_gpr, IOMUXC_GPR14,
> --
> 2.45.2
>