[PATCH] firmware: arm_scmi: use ioread64() instead of ioread64_hi_lo()

[Arnd Bergmann]

From: Arnd Bergmann <arnd at arndb.de>

The scmi_common_fastchannel_db_ring() function calls either ioread64()
or ioread64_hi_lo() depending on whether it is compiler for 32-bit
or 64-bit architectures.

The same logic is used to define ioread64() itself in the
linux/io-64-nonatomic-hi-lo.h header file, so the special case
is not really needed.

The behavior here should not change at all.

Fixes: 6f9ea4dabd2d ("firmware: arm_scmi: Generalize the fast channel support")
Signed-off-by: Arnd Bergmann <arnd at arndb.de>
---
 drivers/firmware/arm_scmi/driver.c | 10 ----------
 1 file changed, 10 deletions(-)

diff --git a/drivers/firmware/arm_scmi/driver.c b/drivers/firmware/arm_scmi/driver.c
index 60050da54bf2..1c75a4c9c371 100644
--- a/drivers/firmware/arm_scmi/driver.c
+++ b/drivers/firmware/arm_scmi/driver.c
@@ -1997,17 +1997,7 @@ static void scmi_common_fastchannel_db_ring(struct scmi_fc_db_info *db)
 	else if (db->width == 4)
 		SCMI_PROTO_FC_RING_DB(32);
 	else /* db->width == 8 */
-#ifdef CONFIG_64BIT
 		SCMI_PROTO_FC_RING_DB(64);
-#else
-	{
-		u64 val = 0;
-
-		if (db->mask)
-			val = ioread64_hi_lo(db->addr) & db->mask;
-		iowrite64_hi_lo(db->set | val, db->addr);
-	}
-#endif
 }
 
 /**
-- 
2.39.5