[PATCH RFC net-next 1/3] net: phylink: add config of PHY receive clock-stop in phylink_resume()

[Russell King (Oracle)]

Add configuration of the receive clock-stop in phylink_resume() to
ensure that the clock-stop is correctly configured.

Reviewed-by: Andrew Lunn <andrew at lunn.ch>
Signed-off-by: Russell King (Oracle) <rmk+kernel at armlinux.org.uk>
---
 drivers/net/phy/phylink.c | 16 +++++++++++++++-
 1 file changed, 15 insertions(+), 1 deletion(-)

diff --git a/drivers/net/phy/phylink.c b/drivers/net/phy/phylink.c
index a3b186ab3854..0aae0bb2a254 100644
--- a/drivers/net/phy/phylink.c
+++ b/drivers/net/phy/phylink.c
@@ -2264,7 +2264,7 @@ static int phylink_bringup_phy(struct phylink *pl, struct phy_device *phy,
 	pl->mac_tx_clk_stop = phy_eee_tx_clock_stop_capable(phy) > 0;
 
 	if (pl->mac_supports_eee_ops) {
-		/* Explicitly configure whether the PHY is allowed to stop it's
+		/* Explicitly configure whether the PHY is allowed to stop its
 		 * receive clock.
 		 */
 		ret = phy_eee_rx_clock_stop(phy,
@@ -2645,8 +2645,22 @@ EXPORT_SYMBOL_GPL(phylink_suspend);
  */
 void phylink_resume(struct phylink *pl)
 {
+	int ret;
+
 	ASSERT_RTNL();
 
+	if (pl->mac_supports_eee_ops && pl->phydev) {
+		/* Explicitly configure whether the PHY is allowed to stop its
+		 * receive clock on resume to ensure that it is correctly
+		 * configured.
+		 */
+		ret = phy_eee_rx_clock_stop(pl->phydev,
+					    pl->config->eee_rx_clk_stop_enable);
+		if (ret == -EOPNOTSUPP)
+			phylink_warn(pl, "failed to set rx clock stop: %pe\n",
+				     ERR_PTR(ret));
+	}
+
 	if (test_bit(PHYLINK_DISABLE_MAC_WOL, &pl->phylink_disable_state)) {
 		/* Wake-on-Lan enabled, MAC handling */
 
-- 
2.30.2