[PATCH net-next v4 08/13] net: phy: phy_device: Use link_capabilities lookup for PHY aneg config

[Maxime Chevallier]

When configuring PHY advertising with autoneg disabled, we lookd for an
exact linkmode to advertise and configure for the requested Speed and
Duplex, specially at or over 1G.

Using phy_caps_lookup allows us to build a list of the supported
linkmodes at that speed that we can advertise instead of the first mode
that matches.

Signed-off-by: Maxime Chevallier <maxime.chevallier at bootlin.com>
---
V4: No changes

 drivers/net/phy/phy_device.c | 11 ++++++-----
 1 file changed, 6 insertions(+), 5 deletions(-)

diff --git a/drivers/net/phy/phy_device.c b/drivers/net/phy/phy_device.c
index 9c573555ac49..57b90ec6477e 100644
--- a/drivers/net/phy/phy_device.c
+++ b/drivers/net/phy/phy_device.c
@@ -2357,7 +2357,7 @@ EXPORT_SYMBOL(genphy_check_and_restart_aneg);
 int __genphy_config_aneg(struct phy_device *phydev, bool changed)
 {
 	__ETHTOOL_DECLARE_LINK_MODE_MASK(fixed_advert);
-	const struct phy_setting *set;
+	const struct link_capabilities *c;
 	unsigned long *advert;
 	int err;
 
@@ -2383,10 +2383,11 @@ int __genphy_config_aneg(struct phy_device *phydev, bool changed)
 	} else {
 		linkmode_zero(fixed_advert);
 
-		set = phy_lookup_setting(phydev->speed, phydev->duplex,
-					 phydev->supported, true);
-		if (set)
-			linkmode_set_bit(set->bit, fixed_advert);
+		c = phy_caps_lookup(phydev->speed, phydev->duplex,
+				    phydev->supported, true);
+		if (c)
+			linkmode_and(fixed_advert, phydev->supported,
+				     c->linkmodes);
 
 		advert = fixed_advert;
 	}
-- 
2.48.1