[PATCH v2 07/10] dt-bindings: phy: Add PHY bindings support for FSD SoC

[Rob Herring]

On Wed, Jun 25, 2025 at 10:22:26PM +0530, Shradha Todi wrote:
> Document PHY device tree bindings for Tesla FSD SoCs.
> 
> Signed-off-by: Shradha Todi <shradha.t at samsung.com>
> ---
>  .../bindings/phy/samsung,exynos-pcie-phy.yaml | 25 +++++++++++++++++--
>  1 file changed, 23 insertions(+), 2 deletions(-)
> 
> diff --git a/Documentation/devicetree/bindings/phy/samsung,exynos-pcie-phy.yaml b/Documentation/devicetree/bindings/phy/samsung,exynos-pcie-phy.yaml
> index 41df8bb08ff7..4dc20156cdde 100644
> --- a/Documentation/devicetree/bindings/phy/samsung,exynos-pcie-phy.yaml
> +++ b/Documentation/devicetree/bindings/phy/samsung,exynos-pcie-phy.yaml
> @@ -15,10 +15,13 @@ properties:
>      const: 0
>  
>    compatible:
> -    const: samsung,exynos5433-pcie-phy
> +    enum:
> +      - samsung,exynos5433-pcie-phy
> +      - tesla,fsd-pcie-phy
>  
>    reg:
> -    maxItems: 1
> +    minItems: 1
> +    maxItems: 2
>  
>    samsung,pmu-syscon:
>      $ref: /schemas/types.yaml#/definitions/phandle
> @@ -30,6 +33,24 @@ properties:
>      description: phandle for FSYS sysreg interface, used to control
>                   sysreg registers bits for PCIe PHY
>  
> +allOf:
> +  - if:
> +      properties:
> +        compatible:
> +          contains:
> +            enum:
> +              - tesla,fsd-pcie-phy
> +    then:
> +      description:
> +        The PHY controller nodes are represented in the aliases node
> +        using the following format 'pciephy{n}'. Depending on whether
> +        n is 0 or 1, the phy init sequence is chosen.

What? Don't make up your own aliases.

If the PHY instances are different, then maybe you need a different 
compatible. If this is just selecting the PHY mode, you can do that in 
PHY cells as the mode depends on the consumer.


> +      properties:
> +        reg:
> +          items:
> +            - description: PHY
> +            - description: PCS

else:
  properties:
    reg:
      maxItems: 1

> +
>  required:
>    - "#phy-cells"
>    - compatible
> -- 
> 2.49.0
>