[PATCH v3 0/6] PCI: dwc: Do not enumerate bus before endpoint devices are ready
Niklas Cassel
cassel at kernel.org
Mon Jun 23 03:12:44 PDT 2025
On Fri, Jun 13, 2025 at 02:48:39PM +0200, Niklas Cassel wrote:
> Hello all,
>
> The DWC PCIe controller driver currently does not follow the PCIe
> specification with regards to the delays after link training, before
> sending out configuration requests. This series fixes this.
>
> At the same time, PATCH 1/4 addresses a regression where a Plextor
> NVMe drive fails to be configured correctly. With this series, the
> Plextor NVMe drive works once again.
>
>
> Kind regards,
> Niklas
>
>
> Changes since v2:
> -Rename PCIE_RESET_CONFIG_DEVICE_WAIT_MS to PCIE_RESET_CONFIG_WAIT_MS.
>
>
> Niklas Cassel (6):
> PCI: Rename PCIE_RESET_CONFIG_DEVICE_WAIT_MS to
> PCIE_RESET_CONFIG_WAIT_MS
> PCI: rockchip-host: Use macro PCIE_RESET_CONFIG_WAIT_MS
> PCI: dw-rockchip: Wait PCIE_RESET_CONFIG_WAIT_MS after link-up IRQ
> PCI: qcom: Wait PCIE_RESET_CONFIG_WAIT_MS after link-up IRQ
> PCI: dwc: Ensure that dw_pcie_wait_for_link() waits 100 ms after link
> up
> PCI: dwc: Reduce LINK_WAIT_SLEEP_MS
>
> drivers/pci/controller/dwc/pcie-designware.c | 13 ++++++++++++-
> drivers/pci/controller/dwc/pcie-designware.h | 13 +++++++++----
> drivers/pci/controller/dwc/pcie-dw-rockchip.c | 1 +
> drivers/pci/controller/dwc/pcie-qcom.c | 1 +
> drivers/pci/controller/pcie-rockchip-host.c | 2 +-
> drivers/pci/controller/plda/pcie-starfive.c | 2 +-
> drivers/pci/pci.h | 9 +--------
> 7 files changed, 26 insertions(+), 15 deletions(-)
>
> --
> 2.49.0
>
Gentle ping
More information about the linux-arm-kernel
mailing list