[PATCH 4/5] arm64: dts: allwinner: a523: Add UART1 pins

[Andre Przywara]

On Fri, 20 Jun 2025 01:30:06 +0800
Chen-Yu Tsai <wens at kernel.org> wrote:

> From: Chen-Yu Tsai <wens at csie.org>
> 
> UART1 is normally used to connect to the Bluetooth side of a Broadcom
> WiFi+BT combo chip. The connection uses 4 pins.
> 
> Add pinmux nodes for UART1, one for the RX/TX pins, and one for the
> RTS/CTS pins.

Interestingly there is only one possible set of pins for UART1, so the
naming is correct. Which would also mean we can insert the pinctrl-0
property in the UART DT node in the .dtsi file already.
Regardless, checked against the manual:

> Signed-off-by: Chen-Yu Tsai <wens at csie.org>

Reviewed-by: Andre Przywara <andre.przywara at arm.com>

Cheers,
Andre

> ---
>  arch/arm64/boot/dts/allwinner/sun55i-a523.dtsi | 14 ++++++++++++++
>  1 file changed, 14 insertions(+)
> 
> diff --git a/arch/arm64/boot/dts/allwinner/sun55i-a523.dtsi b/arch/arm64/boot/dts/allwinner/sun55i-a523.dtsi
> index 30613a0b1124..6f62201fd739 100644
> --- a/arch/arm64/boot/dts/allwinner/sun55i-a523.dtsi
> +++ b/arch/arm64/boot/dts/allwinner/sun55i-a523.dtsi
> @@ -168,6 +168,20 @@ uart0_pb_pins: uart0-pb-pins {
>  				allwinner,pinmux = <2>;
>  				function = "uart0";
>  			};
> +
> +			/omit-if-no-ref/
> +			uart1_pins: uart1-pins {
> +				pins = "PG6", "PG7";
> +				function = "uart1";
> +				allwinner,pinmux = <2>;
> +			};
> +
> +			/omit-if-no-ref/
> +			uart1_rts_cts_pins: uart1-rts-cts-pins {
> +				pins = "PG8", "PG9";
> +				function = "uart1";
> +				allwinner,pinmux = <2>;
> +			};
>  		};
>  
>  		ccu: clock-controller at 2001000 {