[PATCH 12/12] gpio: sa1100: use new GPIO line value setter callbacks

[Bartosz Golaszewski]

From: Bartosz Golaszewski <bartosz.golaszewski at linaro.org>

struct gpio_chip now has callbacks for setting line values that return
an integer, allowing to indicate failures. Convert the driver to using
them.

Signed-off-by: Bartosz Golaszewski <bartosz.golaszewski at linaro.org>
---
 drivers/gpio/gpio-sa1100.c | 7 +++++--
 1 file changed, 5 insertions(+), 2 deletions(-)

diff --git a/drivers/gpio/gpio-sa1100.c b/drivers/gpio/gpio-sa1100.c
index 3f3ee36bc3cb19a7baf530def0575d2ff09dd3c5..e9d054d78ccb8485b9f662fcec385fe0d0edc0d7 100644
--- a/drivers/gpio/gpio-sa1100.c
+++ b/drivers/gpio/gpio-sa1100.c
@@ -43,11 +43,14 @@ static int sa1100_gpio_get(struct gpio_chip *chip, unsigned offset)
 		BIT(offset);
 }
 
-static void sa1100_gpio_set(struct gpio_chip *chip, unsigned offset, int value)
+static int sa1100_gpio_set(struct gpio_chip *chip, unsigned int offset,
+			   int value)
 {
 	int reg = value ? R_GPSR : R_GPCR;
 
 	writel_relaxed(BIT(offset), sa1100_gpio_chip(chip)->membase + reg);
+
+	return 0;
 }
 
 static int sa1100_get_direction(struct gpio_chip *chip, unsigned offset)
@@ -96,7 +99,7 @@ static struct sa1100_gpio_chip sa1100_gpio_chip = {
 		.get_direction		= sa1100_get_direction,
 		.direction_input	= sa1100_direction_input,
 		.direction_output	= sa1100_direction_output,
-		.set			= sa1100_gpio_set,
+		.set_rv			= sa1100_gpio_set,
 		.get			= sa1100_gpio_get,
 		.to_irq			= sa1100_to_irq,
 		.base			= 0,

-- 
2.48.1