[PATCH v2 1/9] dt-bindings: spi: Add spi-buses property

[Krzysztof Kozlowski]

On 17/06/2025 00:00, Sean Anderson wrote:
> From: David Lechner <dlechner at baylibre.com>
> 
> Add a spi-buses property to the spi-peripheral-props binding to allow
> specifying the SPI bus or buses that a peripheral is connected to in
> cases where the SPI controller has more than one physical SPI bus.
> 
> Signed-off-by: David Lechner <dlechner at baylibre.com>
> Signed-off-by: Sean Anderson <sean.anderson at linux.dev>
> ---
> 
> Changes in v2:
> - New
> 
>  .../devicetree/bindings/spi/spi-peripheral-props.yaml  | 10 ++++++++++
>  1 file changed, 10 insertions(+)

<form letter>
Please use scripts/get_maintainers.pl to get a list of necessary people
and lists to CC. It might happen, that command when run on an older
kernel, gives you outdated entries. Therefore please be sure you base
your patches on recent Linux kernel.

Tools like b4 or scripts/get_maintainer.pl provide you proper list of
people, so fix your workflow. Tools might also fail if you work on some
ancient tree (don't, instead use mainline) or work on fork of kernel
(don't, instead use mainline). Just use b4 and everything should be
fine, although remember about `b4 prep --auto-to-cc` if you added new
patches to the patchset.

You missed at least devicetree list (maybe more), so this won't be
tested by automated tooling. Performing review on untested code might be
a waste of time.

Please kindly resend and include all necessary To/Cc entries.
</form letter>

Best regards,
Krzysztof