[PATCH 2/2] ARM: dts: s5pv210: Align i2c-gpio node names with dtschema

[Krzysztof Kozlowski]

New dtschema v2025.6 enforces different naming on I2C nodes thus new
dtbs_check warnings appeared for I2C GPIO nodes:

  s5pv210-fascinate4g.dtb: i2c-gpio-0 (i2c-gpio):
    $nodename:0: 'i2c-gpio-0' does not match '^i2c(@.+|-[a-z0-9]+)?$'
  s5pv210-fascinate4g.dtb: i2c-gpio-0 (i2c-gpio):
    Unevaluated properties are not allowed ('#address-cells', '#size-cells', 'audio-codec at 1a' were unexpected)

Rename the nodes to a generic i2c-[0-9]+ style with numbers continuing
the SoC I2C controller indexing (3 controllers) for simplicity and
obviousness, even if the SoC I2C controller is not enabled on given
board.  The names anyway would not conflict with SoC ones because of
unit addresses.

Verified with comparing two fdt (after fdtdump).

Reported-by: Wolfram Sang <wsa+renesas at sang-engineering.com>
Closes: https://lore.kernel.org/all/aCtD7BH5N_uPGkq7@shikoro/
Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski at linaro.org>
---
 arch/arm/boot/dts/samsung/s5pv210-aquila.dts  |  2 +-
 arch/arm/boot/dts/samsung/s5pv210-aries.dtsi  | 16 ++++++++--------
 arch/arm/boot/dts/samsung/s5pv210-galaxys.dts |  2 +-
 arch/arm/boot/dts/samsung/s5pv210-goni.dts    |  2 +-
 4 files changed, 11 insertions(+), 11 deletions(-)

diff --git a/arch/arm/boot/dts/samsung/s5pv210-aquila.dts b/arch/arm/boot/dts/samsung/s5pv210-aquila.dts
index 0f5c6cd0f3a1..e9ec2cc718e0 100644
--- a/arch/arm/boot/dts/samsung/s5pv210-aquila.dts
+++ b/arch/arm/boot/dts/samsung/s5pv210-aquila.dts
@@ -62,7 +62,7 @@ bat_reg: regulator-2 {
 		regulator-max-microvolt = <3700000>;
 	};
 
-	i2c_pmic: i2c-pmic {
+	i2c_pmic: i2c-3 {
 		compatible = "i2c-gpio";
 		sda-gpios = <&gpj4 0 GPIO_ACTIVE_HIGH>;
 		scl-gpios = <&gpj4 3 GPIO_ACTIVE_HIGH>;
diff --git a/arch/arm/boot/dts/samsung/s5pv210-aries.dtsi b/arch/arm/boot/dts/samsung/s5pv210-aries.dtsi
index 153514e80c9a..0a1a35f4f7cc 100644
--- a/arch/arm/boot/dts/samsung/s5pv210-aries.dtsi
+++ b/arch/arm/boot/dts/samsung/s5pv210-aries.dtsi
@@ -102,7 +102,7 @@ wifi_pwrseq: wifi-pwrseq {
 		power-off-delay-us = <500>;
 	};
 
-	i2c_sound: i2c-gpio-0 {
+	i2c_sound: i2c-3 {
 		compatible = "i2c-gpio";
 		sda-gpios = <&mp05 3 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>;
 		scl-gpios = <&mp05 2 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>;
@@ -150,7 +150,7 @@ wm8994: audio-codec at 1a {
 		};
 	};
 
-	i2c_accel: i2c-gpio-1 {
+	i2c_accel: i2c-4 {
 		compatible = "i2c-gpio";
 		sda-gpios = <&gpj3 6 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>;
 		scl-gpios = <&gpj3 7 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>;
@@ -170,7 +170,7 @@ accelerometer at 38 {
 		};
 	};
 
-	i2c_pmic: i2c-gpio-2 {
+	i2c_pmic: i2c-5 {
 		compatible = "i2c-gpio";
 		sda-gpios = <&gpj4 0 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>;
 		scl-gpios = <&gpj4 3 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>;
@@ -420,7 +420,7 @@ safe2_sreg: ESAFEOUT2 {
 		};
 	};
 
-	i2c_musb: i2c-gpio-3 {
+	i2c_musb: i2c-6 {
 		compatible = "i2c-gpio";
 		sda-gpios = <&gpj3 4 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>;
 		scl-gpios = <&gpj3 5 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>;
@@ -442,7 +442,7 @@ fsa9480: musb at 25 {
 		};
 	};
 
-	i2c_fuel: i2c-gpio-4 {
+	i2c_fuel: i2c-7 {
 		compatible = "i2c-gpio";
 		sda-gpios = <&mp05 1 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>;
 		scl-gpios = <&mp05 0 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>;
@@ -459,7 +459,7 @@ fg: fuelgauge at 36 {
 		};
 	};
 
-	i2c_touchkey: i2c-gpio-5 {
+	i2c_touchkey: i2c-8 {
 		compatible = "i2c-gpio";
 		sda-gpios = <&gpj3 0 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>;
 		scl-gpios = <&gpj3 1 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>;
@@ -485,7 +485,7 @@ touchkey at 20 {
 		};
 	};
 
-	i2c_prox: i2c-gpio-6 {
+	i2c_prox: i2c-9 {
 		compatible = "i2c-gpio";
 		sda-gpios = <&gpg2 2 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>;
 		scl-gpios = <&gpg0 2 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>;
@@ -513,7 +513,7 @@ light-sensor at 44 {
 		};
 	};
 
-	i2c_magnetometer: i2c-gpio-7 {
+	i2c_magnetometer: i2c-10 {
 		compatible = "i2c-gpio";
 		sda-gpios = <&gpj0 1 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>;
 		scl-gpios = <&gpj0 0 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>;
diff --git a/arch/arm/boot/dts/samsung/s5pv210-galaxys.dts b/arch/arm/boot/dts/samsung/s5pv210-galaxys.dts
index 879294412381..5863a1300cc1 100644
--- a/arch/arm/boot/dts/samsung/s5pv210-galaxys.dts
+++ b/arch/arm/boot/dts/samsung/s5pv210-galaxys.dts
@@ -51,7 +51,7 @@ key-home {
 		};
 	};
 
-	i2c_fmradio: i2c-gpio-8 {
+	i2c_fmradio: i2c-11 {
 		compatible = "i2c-gpio";
 		sda-gpios = <&gpd1 2 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>;
 		scl-gpios = <&gpd1 3 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>;
diff --git a/arch/arm/boot/dts/samsung/s5pv210-goni.dts b/arch/arm/boot/dts/samsung/s5pv210-goni.dts
index d32f42dd1bf5..079581f4dfec 100644
--- a/arch/arm/boot/dts/samsung/s5pv210-goni.dts
+++ b/arch/arm/boot/dts/samsung/s5pv210-goni.dts
@@ -74,7 +74,7 @@ tsp_reg: regulator-3 {
 		enable-active-high;
 	};
 
-	i2c_pmic: i2c-pmic {
+	i2c_pmic: i2c-3 {
 		compatible = "i2c-gpio";
 		sda-gpios = <&gpj4 0 GPIO_ACTIVE_HIGH>;
 		scl-gpios = <&gpj4 3 GPIO_ACTIVE_HIGH>;
-- 
2.45.2