[PATCH v4 2/2] PCI: xilinx: Support reset GPIO for PERST#

[Bjorn Helgaas]

On Tue, Jun 10, 2025 at 04:39:04PM +0200, Mike Looijmans wrote:
> Support providing the PERST# reset signal through a devicetree binding.
> Thus the system no longer relies on external components to perform the
> bus reset.

> @@ -576,11 +577,17 @@ static int xilinx_pcie_probe(struct platform_device *pdev)
>  	struct device *dev = &pdev->dev;
>  	struct xilinx_pcie *pcie;
>  	struct pci_host_bridge *bridge;
> +	struct gpio_desc *perst_gpio;
>  	int err;
>  
>  	if (!dev->of_node)
>  		return -ENODEV;
>  
> +	perst_gpio = devm_gpiod_get_optional(dev, "reset", GPIOD_OUT_HIGH);
> +	if (IS_ERR(perst_gpio))
> +		return dev_err_probe(dev, PTR_ERR(perst_gpio),
> +				     "Failed to request reset GPIO\n");
> +
>  	bridge = devm_pci_alloc_host_bridge(dev, sizeof(*pcie));
>  	if (!bridge)
>  		return -ENODEV;
> @@ -595,6 +602,13 @@ static int xilinx_pcie_probe(struct platform_device *pdev)
>  		return err;
>  	}
>  
> +	if (perst_gpio) {
> +		msleep(PCIE_T_PVPERL_MS); /* Minimum assertion time */
> +		gpiod_set_value_cansleep(perst_gpio, 0);

Are we assured that PERST# was already asserted when we entered
xilinx_pcie_probe()?

> +		/* Initial delay to provide endpoint time to initialize */
> +		msleep(PCIE_T_RRS_READY_MS);

I don't think this is the right spot for PCIE_T_RRS_READY_MS, details
in https://lore.kernel.org/r/20250610185734.GA819344@bhelgaas

I guess the spec assumes that for ports that don't support speeds
greater than 5.0 GT/s, 100ms is enough for the link to come up *and*
the endpoint to initialize.  But since you're going to wait for the
link to come up immediately *after* this PCIE_T_RRS_READY_MS sleep, I
would think you could extend the timeout in xilinx_pci_wait_link_up()
and then do the PCIE_T_RRS_READY_MS sleep.