[PATCH v2 1/3] PCI/pwrctrl: Add optional slot clock to pwrctrl driver for PCI slots

[Bartosz Golaszewski]

On Sat, May 31, 2025 at 12:55 AM Marek Vasut
<marek.vasut+renesas at mailbox.org> wrote:
>
> Add the ability to enable optional slot clock into the pwrctrl driver.
> This is used to enable slot clock in split-clock topologies, where the
> PCIe host/controller supply and PCIe slot supply are not provided by
> the same clock. The PCIe host/controller clock should be described in
> the controller node as the controller clock, while the slot clock should
> be described in controller bridge/slot subnode.
>
> Example DT snippet:
> &pcicontroller {
>     clocks = <&clk_dif 0>;             /* PCIe controller clock */
>
>     pci at 0,0 {
>         #address-cells = <3>;
>         #size-cells = <2>;
>         reg = <0x0 0x0 0x0 0x0 0x0>;
>         compatible = "pciclass,0604";
>         device_type = "pci";
>         clocks = <&clk_dif 1>;         /* PCIe slot clock */
>         vpcie3v3-supply = <&reg_3p3v>;
>         ranges;
>     };
> };
>
> Example clock topology:
>  ____________                    ____________
> |  PCIe host |                  | PCIe slot  |
> |            |                  |            |
> |    PCIe RX<|==================|>PCIe TX    |
> |    PCIe TX<|==================|>PCIe RX    |
> |            |                  |            |
> |   PCIe CLK<|======..  ..======|>PCIe CLK   |
> '------------'      ||  ||      '------------'
>                     ||  ||
>  ____________       ||  ||
> |  9FGV0441  |      ||  ||
> |            |      ||  ||
> |   CLK DIF0<|======''  ||
> |   CLK DIF1<|==========''
> |   CLK DIF2<|
> |   CLK DIF3<|
> '------------'
>
> Reviewed-by: Anand Moon <linux.amoon at gmail.com>
> Reviewed-by: Manivannan Sadhasivam <manivannan.sadhasivam at linaro.org>
> Signed-off-by: Marek Vasut <marek.vasut+renesas at mailbox.org>
> ---

Acked-by: Bartosz Golaszewski <bartosz.golaszewski at linaro.org>