[PATCH net-next v3 4/7] net: axienet: Simplify axienet_mdio_setup

[Sean Anderson]

We always put the mdio_node and disable the bus after probing, so
perform these steps unconditionally.

Signed-off-by: Sean Anderson <sean.anderson at linux.dev>
---

(no changes since v1)

 drivers/net/ethernet/xilinx/xilinx_axienet_mdio.c | 15 +++++----------
 1 file changed, 5 insertions(+), 10 deletions(-)

diff --git a/drivers/net/ethernet/xilinx/xilinx_axienet_mdio.c b/drivers/net/ethernet/xilinx/xilinx_axienet_mdio.c
index cacd5590731d..2799d168ed9d 100644
--- a/drivers/net/ethernet/xilinx/xilinx_axienet_mdio.c
+++ b/drivers/net/ethernet/xilinx/xilinx_axienet_mdio.c
@@ -302,19 +302,14 @@ int axienet_mdio_setup(struct axienet_local *lp)
 	ret = axienet_mdio_enable(bus, mdio_node);
 	if (ret < 0)
 		goto unregister;
+
 	ret = of_mdiobus_register(bus, mdio_node);
-	if (ret)
-		goto unregister_mdio_enabled;
 	of_node_put(mdio_node);
 	axienet_mdio_mdc_disable(lp);
-	return 0;
-
-unregister_mdio_enabled:
-	axienet_mdio_mdc_disable(lp);
-unregister:
-	of_node_put(mdio_node);
-	mdiobus_free(bus);
-	lp->mii_bus = NULL;
+	if (ret) {
+		mdiobus_free(bus);
+		lp->mii_bus = NULL;
+	}
 	return ret;
 }
 
-- 
2.35.1.1320.gc452695387.dirty