[PATCH v2 6/7] arm64: dts: ti: k3-j721s2-common-proc-board: Enable DisplayPort-1

Jayesh Choudhary j-choudhary at ti.com
Tue Jul 15 22:42:22 PDT 2025


Hello Udit,

On 26/06/25 16:04, Kumar, Udit wrote:
> 
> On 6/24/2025 1:56 PM, Jayesh Choudhary wrote:
>> Enable DSI display for J721S2 EVM.
>>
>> Add the endpoint nodes to describe connection from:
>> DSS => DSI Bridge => DSI to eDP bridge => DisplayPort-1
>>
>> Set status for all required nodes for DisplayPort-1 as 'okay'.
>>
>> Signed-off-by: Jayesh Choudhary <j-choudhary at ti.com>
>> ---
>>   .../dts/ti/k3-j721s2-common-proc-board.dts    | 89 +++++++++++++++++++
>>   1 file changed, 89 insertions(+)
>>
>> diff --git a/arch/arm64/boot/dts/ti/k3-j721s2-common-proc-board.dts 
>> b/arch/arm64/boot/dts/ti/k3-j721s2-common-proc-board.dts
>> index 793d50344fad..efe857a50bb1 100644
>> --- a/arch/arm64/boot/dts/ti/k3-j721s2-common-proc-board.dts
>> +++ b/arch/arm64/boot/dts/ti/k3-j721s2-common-proc-board.dts
>> @@ -93,6 +93,29 @@ vdd_sd_dv: gpio-regulator-TLV71033 {
>>                <3300000 0x1>;
>>       };
>> +    dp1_pwr_3v3: regulator-dp1-prw {
>> +        compatible = "regulator-fixed";
>> +        regulator-name = "dp1-pwr";
>> +        regulator-min-microvolt = <3300000>;
>> +        regulator-max-microvolt = <3300000>;
>> +        gpio = <&exp4 1 GPIO_ACTIVE_HIGH>; /* P1 - DP1_PWR_SW_EN */
>> +        enable-active-high;
>> +        regulator-always-on;
> 
> Please check once, if this regulator falls under regulator-always-on case,
> 
> I can imagine a case, where DP1 is not used and still regulator is kept on

Yes it is not required.
I will remove this property from j721s2-common-proc-board and am68-sk
board dts.

Thanks,
Jayesh

> 
> 
>> +    };
>> +
>> +    dp1: connector-dp1 {
>> +        compatible = "dp-connector";

[...]



More information about the linux-arm-kernel mailing list