[PATCH v2 1/2] gpio: wcove: use regmap_assign_bits() in .set()

[Sathyanarayanan Kuppuswamy]

On 7/15/25 1:19 AM, Bartosz Golaszewski wrote:
> From: Bartosz Golaszewski <bartosz.golaszewski at linaro.org>
>
> Replace the if-else with a direct call to the regmap_assign_bits()
> helper and save a couple lines of code.
>
> Signed-off-by: Bartosz Golaszewski <bartosz.golaszewski at linaro.org>
> ---

Reviewed-by: Kuppuswamy Sathyanarayanan <sathyanarayanan.kuppuswamy at linux.intel.com>

>   drivers/gpio/gpio-wcove.c | 5 +----
>   1 file changed, 1 insertion(+), 4 deletions(-)
>
> diff --git a/drivers/gpio/gpio-wcove.c b/drivers/gpio/gpio-wcove.c
> index 1ec24f6f9300f33f5b3f0f8deb539e08392b8188..816fb8d113e66b27070f286755f3192b2a8f8512 100644
> --- a/drivers/gpio/gpio-wcove.c
> +++ b/drivers/gpio/gpio-wcove.c
> @@ -208,10 +208,7 @@ static void wcove_gpio_set(struct gpio_chip *chip, unsigned int gpio, int value)
>   	if (reg < 0)
>   		return;
>   
> -	if (value)
> -		regmap_set_bits(wg->regmap, reg, 1);
> -	else
> -		regmap_clear_bits(wg->regmap, reg, 1);
> +	regmap_assign_bits(wg->regmap, reg, 1, value);
>   }
>   
>   static int wcove_gpio_set_config(struct gpio_chip *chip, unsigned int gpio,
>
-- 
Sathyanarayanan Kuppuswamy
Linux Kernel Developer