[PATCH net-next v10 04/11] net: ti: prueth: Adds link detection, RX and TX support.

Parvathi Pudi parvathi at couthit.com
Fri Jul 11 05:33:08 PDT 2025


Hi,

> On Wed,  2 Jul 2025 20:47:49 +0530 Parvathi Pudi wrote:
>> +			if (emac->port_id) {
>> +				regmap_update_bits
>> +					(prueth->mii_rt,
>> +					 PRUSS_MII_RT_TXCFG1,
>> +					 PRUSS_MII_RT_TXCFG_TX_CLK_DELAY_MASK,
>> +					 delay);
> 
> Instead of breaking the lines up like this you should factor the code
> out or find some other way to reduce the indentation.
> 

Sure, we will address this in the next version.

>> +	qid = icssm_prueth_get_tx_queue_id(emac->prueth, skb);
>> +	ret = icssm_prueth_tx_enqueue(emac, skb, qid);
>> +	if (ret) {
>> +		if (ret != -ENOBUFS && netif_msg_tx_err(emac) &&
>> +		    net_ratelimit())
>> +			netdev_err(ndev, "packet queue failed: %d\n", ret);
>> +		goto fail_tx;
>> +	}
> 
>> +	if (ret == -ENOBUFS) {
>> +		ret = NETDEV_TX_BUSY;
> 
> 
> Something needs to stop the queue, right? Otherwise the stack will
> send the frame right back to the driver.
> 

Yes, we will notify upper layer with “netif_tx_stop_queue()” when returning
“NETDEV_TX_BUSY” to not push again immediately.

>> +static inline void icssm_emac_finish_napi(struct prueth_emac *emac,
>> +					  struct napi_struct *napi,
>> +					  int irq)
>> +{
>> +	napi_complete(napi);
>> +	enable_irq(irq);
> 
> This helper has a single caller, just put the two lines of code directly
> there. And use napi_complete_done(), please.

We will address this in the next version.

Thanks and Regards,
Parvathi.



More information about the linux-arm-kernel mailing list