[PATCH v7 01/12] dt-bindings: mfd: add support for the NXP SIUL2 module

[Krzysztof Kozlowski]

On Thu, Jul 10, 2025 at 05:20:24PM +0300, Andrei Stefanescu wrote:
> +        properties:
> +          bias-disable: true
> +          bias-high-impedance: true
> +          bias-pull-up: true
> +          bias-pull-down: true
> +          drive-open-drain: true
> +          input-enable: true
> +          output-enable: true
> +
> +          pinmux:
> +            description: |
> +              An integer array for representing pinmux configurations of
> +              a device. Each integer consists of a PIN_ID and a 4-bit
> +              selected signal source(SSS) as IOMUX setting, which is
> +              calculated as: pinmux = (PIN_ID << 4 | SSS)
> +
> +          slew-rate:
> +            description: Supported slew rate based on Fmax values (MHz)
> +            enum: [83, 133, 150, 166, 208]
> +        required:
> +          - pinmux
> +
> +        unevaluatedProperties: false

I noticed Frank's comment and he pointed out that this changed, so all
':true' lines before should be removed as well.

Best regards,
Krzysztof