[PATCH 10/19] gpio: xilinx: use new GPIO line value setter callbacks

[Bartosz Golaszewski]

From: Bartosz Golaszewski <bartosz.golaszewski at linaro.org>

struct gpio_chip now has callbacks for setting line values that return
an integer, allowing to indicate failures. Convert the driver to using
them.

Signed-off-by: Bartosz Golaszewski <bartosz.golaszewski at linaro.org>
---
 drivers/gpio/gpio-xilinx.c | 6 ++++--
 1 file changed, 4 insertions(+), 2 deletions(-)

diff --git a/drivers/gpio/gpio-xilinx.c b/drivers/gpio/gpio-xilinx.c
index c58a7e1349b4b226057c6d045f901c7fea5da449..aaaa741179805d54e1cd1425579eb52a3579d6e5 100644
--- a/drivers/gpio/gpio-xilinx.c
+++ b/drivers/gpio/gpio-xilinx.c
@@ -148,7 +148,7 @@ static int xgpio_get(struct gpio_chip *gc, unsigned int gpio)
  * This function writes the specified value in to the specified signal of the
  * GPIO device.
  */
-static void xgpio_set(struct gpio_chip *gc, unsigned int gpio, int val)
+static int xgpio_set(struct gpio_chip *gc, unsigned int gpio, int val)
 {
 	unsigned long flags;
 	struct xgpio_instance *chip = gpiochip_get_data(gc);
@@ -162,6 +162,8 @@ static void xgpio_set(struct gpio_chip *gc, unsigned int gpio, int val)
 	xgpio_write_ch(chip, XGPIO_DATA_OFFSET, bit, chip->state);
 
 	raw_spin_unlock_irqrestore(&chip->gpio_lock, flags);
+
+	return 0;
 }
 
 /**
@@ -600,7 +602,7 @@ static int xgpio_probe(struct platform_device *pdev)
 	chip->gc.direction_input = xgpio_dir_in;
 	chip->gc.direction_output = xgpio_dir_out;
 	chip->gc.get = xgpio_get;
-	chip->gc.set = xgpio_set;
+	chip->gc.set_rv = xgpio_set;
 	chip->gc.request = xgpio_request;
 	chip->gc.free = xgpio_free;
 	chip->gc.set_multiple = xgpio_set_multiple;

-- 
2.48.1