[PATCH v3 0/5] Add support for NetCube Systems Nagami SoM and its carrier boards

[Lukas Schmid]

This series adds support for the NetCube Systems Nagami SoM and its
associated carrier boards, the Nagami Basic Carrier and the Nagami Keypad
Carrier.

Changes in v3:
  - Add missing dcxo node to the SoM dtsi

Changes in v2:
 - Squash the binding patches into one patch
 - Fix formatting of the phy node in the SoM dtsi
 - Add description on where the phy is located in the SoM dtsi
 - Fix the phy address in the SoM dtsi
 - Move the carrier bindings into the same description as enums

Signed-off-by: Lukas Schmid <lukas.schmid at netcube.li>
---
Lukas Schmid (5):
  dt-bindings: arm: sunxi: Add NetCube Systems Nagami SoM and carrier
    board bindings
  riscv: dts: allwinner: d1s-t113: Add pinctrl's required by NetCube
    Systems Nagami SoM
  ARM: dts: sunxi: add support for NetCube Systems Nagami SoM
  ARM: dts: sunxi: add support for NetCube Systems Nagami Basic Carrier
  ARM: dts: sunxi: add support for NetCube Systems Nagami Keypad Carrier

 .../devicetree/bindings/arm/sunxi.yaml        |   8 +
 arch/arm/boot/dts/allwinner/Makefile          |   3 +
 ...n8i-t113s-netcube-nagami-basic-carrier.dts |  63 +++++
 ...8i-t113s-netcube-nagami-keypad-carrier.dts | 165 +++++++++++++
 .../allwinner/sun8i-t113s-netcube-nagami.dtsi | 228 ++++++++++++++++++
 .../boot/dts/allwinner/sunxi-d1s-t113.dtsi    |  36 +++
 6 files changed, 503 insertions(+)
 create mode 100644 arch/arm/boot/dts/allwinner/sun8i-t113s-netcube-nagami-basic-carrier.dts
 create mode 100644 arch/arm/boot/dts/allwinner/sun8i-t113s-netcube-nagami-keypad-carrier.dts
 create mode 100644 arch/arm/boot/dts/allwinner/sun8i-t113s-netcube-nagami.dtsi

-- 
2.39.5