[PATCH v3 2/2] ethernet: eswin: Add eic7700 ethernet driver

[Krzysztof Kozlowski]

On 03/07/2025 11:20, weishangjuan at eswincomputing.com wrote:
> +	ret = of_property_read_u32_index(pdev->dev.of_node, "eswin,syscrg_csr", 1,
> +					 &hsp_aclk_ctrl_offset);
> +	if (ret)
> +		return dev_err_probe(&pdev->dev, ret, "can't get hsp_aclk_ctrl_offset\n");
> +
> +	regmap_read(dwc_priv->crg_regmap, hsp_aclk_ctrl_offset, &hsp_aclk_ctrl_regset);
> +	hsp_aclk_ctrl_regset |= (EIC7700_HSP_ACLK_CLKEN | EIC7700_HSP_ACLK_DIVSOR);
> +	regmap_write(dwc_priv->crg_regmap, hsp_aclk_ctrl_offset, hsp_aclk_ctrl_regset);
> +
> +	ret = of_property_read_u32_index(pdev->dev.of_node, "eswin,syscrg_csr", 2,
> +					 &hsp_cfg_ctrl_offset);
> +	if (ret)
> +		return dev_err_probe(&pdev->dev, ret, "can't get hsp_cfg_ctrl_offset\n");
> +
> +	regmap_write(dwc_priv->crg_regmap, hsp_cfg_ctrl_offset, EIC7700_HSP_CFG_CTRL_REGSET);
> +
> +	dwc_priv->hsp_regmap = syscon_regmap_lookup_by_phandle(pdev->dev.of_node,
> +							       "eswin,hsp_sp_csr");

There is no such property. I already said at v2 you cannot have
undocumented ABI.

> +	if (IS_ERR(dwc_priv->hsp_regmap))
> +		return dev_err_probe(&pdev->dev, PTR_ERR(dwc_priv->hsp_regmap),
> +				"Failed to get hsp_sp_csr regmap\n");
> +
> +	ret = of_property_read_u32_index(pdev->dev.of_node, "eswin,hsp_sp_csr", 2,

NAK

> +					 &eth_phy_ctrl_offset);
> +	if (ret)
> +		return dev_err_probe(&pdev->dev, ret, "can't get eth_phy_ctrl_offset\n");
> +
> +	regmap_read(dwc_priv->hsp_regmap, eth_phy_ctrl_offset, &eth_phy_ctrl_regset);
> +	eth_phy_ctrl_regset |= (EIC7700_ETH_TX_CLK_SEL | EIC7700_ETH_PHY_INTF_SELI);
> +	regmap_write(dwc_priv->hsp_regmap, eth_phy_ctrl_offset, eth_phy_ctrl_regset);
> +
> +	ret = of_property_read_u32_index(pdev->dev.of_node, "eswin,hsp_sp_csr", 3,
> +					 &eth_axi_lp_ctrl_offset);
> +	if (ret)
> +		return dev_err_probe(&pdev->dev, ret, "can't get eth_axi_lp_ctrl_offset\n");
> +
> +	regmap_write(dwc_priv->hsp_regmap, eth_axi_lp_ctrl_offset, EIC7700_ETH_CSYSREQ_VAL);
> +
> +	plat_dat->clk_tx_i = devm_clk_get_enabled(&pdev->dev, "tx");
> +	if (IS_ERR(plat_dat->clk_tx_i))
> +		return dev_err_probe(&pdev->dev, PTR_ERR(plat_dat->clk_tx_i),
> +				"error getting tx clock\n");
> +
> +	plat_dat->fix_mac_speed = eic7700_qos_fix_speed;
> +	plat_dat->set_clk_tx_rate = stmmac_set_clk_tx_rate;
> +	plat_dat->bsp_priv = dwc_priv;
> +
> +	ret = stmmac_dvr_probe(&pdev->dev, plat_dat, &stmmac_res);
> +	if (ret)
> +		return dev_err_probe(&pdev->dev, ret, "Failed to driver probe\n");
> +
> +	return ret;
> +}
> +
> +static const struct of_device_id eic7700_dwmac_match[] = {
> +	{ .compatible = "eswin,eic7700-qos-eth" },
> +	{ }
> +};
> +MODULE_DEVICE_TABLE(of, eic7700_dwmac_match);
> +
> +static struct platform_driver eic7700_dwmac_driver = {
> +	.probe  = eic7700_dwmac_probe,
> +	.remove = stmmac_pltfr_remove,
> +	.driver = {
> +		.name           = "eic7700-eth-dwmac",
> +		.pm             = &stmmac_pltfr_pm_ops,
> +		.of_match_table = eic7700_dwmac_match,
> +	},
> +};
> +module_platform_driver(eic7700_dwmac_driver);
> +
> +MODULE_AUTHOR("Eswin");

Drop, that's not a person.


Best regards,
Krzysztof