[PATCH] mtd: nand: raw: atmel: Respect tAR, tCLR in read setup timing

[A. Sverdlin]

From: Alexander Sverdlin <alexander.sverdlin at siemens.com>

Having setup time 0 violates tAR, tCLR of some chips, for instance
TOSHIBA TC58NVG2S3ETAI0 cannot be detected successfully (first ID byte
being read duplicated, i.e. 98 98 dc 90 15 76 14 03 instead of
98 dc 90 15 76 ...).

Atmel Application Notes postulated 1 cycle NRD_SETUP without explanation
[1], but it looks more appropriate to just calculate setup time properly.

Without the fix we've measured -2ns tAR delay (REn asserted before ALE
deassert!); with the fix -- 60ns (subject to module clock).

[1] Link: https://ww1.microchip.com/downloads/aemDocuments/documents/MPU32/ApplicationNotes/ApplicationNotes/doc6255.pdf
Fixes: f9ce2eddf176 ("mtd: nand: atmel: Add ->setup_data_interface() hooks")
Signed-off-by: Alexander Sverdlin <alexander.sverdlin at siemens.com>
---
 drivers/mtd/nand/raw/atmel/nand-controller.c | 17 ++++++++++++++---
 1 file changed, 14 insertions(+), 3 deletions(-)

diff --git a/drivers/mtd/nand/raw/atmel/nand-controller.c b/drivers/mtd/nand/raw/atmel/nand-controller.c
index dedcca87defc7..844df72f45063 100644
--- a/drivers/mtd/nand/raw/atmel/nand-controller.c
+++ b/drivers/mtd/nand/raw/atmel/nand-controller.c
@@ -1377,14 +1377,25 @@ static int atmel_smc_nand_prepare_smcconf(struct atmel_nand *nand,
 	if (ret)
 		return ret;
 
+	/*
+	 * Read setup timing depends on the operation done on the NAND:
+	 *
+	 * NRD_SETUP = max(tAR, tCLR)
+	 */
+	timeps = max(conf->timings.sdr.tAR_min, conf->timings.sdr.tCLR_min);
+	ncycles = DIV_ROUND_UP(timeps, mckperiodps);
+	totalcycles += ncycles;
+	ret = atmel_smc_cs_conf_set_setup(smcconf, ATMEL_SMC_NRD_SHIFT,
+					  ncycles);
+	if (ret)
+		return ret;
+
 	/*
 	 * The read cycle timing is directly matching tRC, but is also
 	 * dependent on the setup and hold timings we calculated earlier,
 	 * which gives:
 	 *
-	 * NRD_CYCLE = max(tRC, NRD_PULSE + NRD_HOLD)
-	 *
-	 * NRD_SETUP is always 0.
+	 * NRD_CYCLE = max(tRC, NRD_SETUP + NRD_PULSE + NRD_HOLD)
 	 */
 	ncycles = DIV_ROUND_UP(conf->timings.sdr.tRC_min, mckperiodps);
 	ncycles = max(totalcycles, ncycles);
-- 
2.50.0