[PATCH 2/6] thermal: of: Export non-devres helper to register/unregister thermal zone

Daniel Lezcano daniel.lezcano at linaro.org
Thu Jan 30 09:24:41 PST 2025


On 30/01/2025 11:30, Claudiu Beznea wrote:
> 
> 
> On 30.01.2025 12:07, Daniel Lezcano wrote:
>> On Thu, Jan 30, 2025 at 11:08:03AM +0200, Claudiu Beznea wrote:
>>> Hi, Daniel,

[ ... ]

>>>> Would the IP need some cycles to capture the temperature accurately after the
>>>> clock is enabled ?
>>>
>>> There is nothing about this mentioned about this in the HW manual of the
>>> RZ/G3S SoC. The only points mentioned are as described in the driver code:
>>> - wait at least 3us after each IIO channel read
>>> - wait at least 30us after enabling the sensor
>>> - wait at least 50us after setting OE bit in TSU_SM
>>>
>>> For this I chose to have it implemented as proposed.
>>
>> IMO, disabling/enabling the clock between two reads through the pm runtime may
>> not be a good thing, especially if the system enters a thermal situation where
>> it has to mitigate.
>>
>> Without any testing capturing the temperatures and compare between the always-on
>> and on/off, it is hard to say if it is true or not. Up to you to test that or
>> not. If you think it is fine, then let's go with it.
> 
> I tested it with and w/o the runtime PM and on/off support (so, everything
> ON from the probe) and the reported temperature values were similar.


Did you remove the roundup to 0.5°C ?


-- 
<http://www.linaro.org/> Linaro.org │ Open source software for ARM SoCs

Follow Linaro:  <http://www.facebook.com/pages/Linaro> Facebook |
<http://twitter.com/#!/linaroorg> Twitter |
<http://www.linaro.org/linaro-blog/> Blog



More information about the linux-arm-kernel mailing list