[RFC v2 PATCH 04/10] net: ti: prueth: Adds link detection, RX and TX support.

[Basharath Hussain Khaja]

> On Fri, Jan 24, 2025 at 07:10:50PM +0530, Basharath Hussain Khaja wrote:
>> From: Roger Quadros <rogerq at ti.com>
>> 
>> Changes corresponding to link configuration such as speed and duplexity.
>> IRQ and handler initializations are performed for packet reception.Firmware
>> receives the packet from the wire and stores it into OCMC queue. Next, it
>> notifies the CPU via interrupt. Upon receiving the interrupt CPU will
>> service the IRQ and packet will be processed by pushing the newly allocated
>> SKB to upper layers.
>> 
>> When the user application want to transmit a packet, it will invoke
>> sys_send() which will inturn invoke the PRUETH driver, then it will write
>> the packet into OCMC queues. PRU firmware will pick up the packet and
>> transmit it on to the wire.
>> 
>> Signed-off-by: Roger Quadros <rogerq at ti.com>
>> Signed-off-by: Andrew F. Davis <afd at ti.com>
>> Signed-off-by: Parvathi Pudi <parvathi at couthit.com>
>> Signed-off-by: Basharath Hussain Khaja <basharath at couthit.com>
>> ---
>>  drivers/net/ethernet/ti/icssm/icssm_prueth.c | 599 ++++++++++++++++++-
>>  drivers/net/ethernet/ti/icssm/icssm_prueth.h |  46 ++
>>  2 files changed, 640 insertions(+), 5 deletions(-)
> 
> Looks like this patch was duplicated and posted twice ?

When I posted the patch first time I received a bounce back error.
So I was not sure if the patch got posted successfully or not so 
I have to re-sent. Sorry for the confusion.


Thanks & Best Regards,
Basharath.