[PATCH net v2 0/3] Limit devicetree parameters to hardware capability
Kunihiko Hayashi
hayashi.kunihiko at socionext.com
Thu Jan 23 20:19:53 PST 2025
Hi Russell,
On 2025/01/24 1:31, Russell King (Oracle) wrote:
> On Thu, Jan 23, 2025 at 02:25:15PM +0900, Kunihiko Hayashi wrote:
>> Hi Russell,
>>
>> Thank you for your comment.
>>
>> On 2025/01/21 19:25, Russell King (Oracle) wrote:
>>> On Tue, Jan 21, 2025 at 01:41:35PM +0900, Kunihiko Hayashi wrote:
>>>> This series includes patches that checks the devicetree properties,
>>>> the number of MTL queues and FIFO size values, and if these
> specified
>>>> values exceed the value contained in the hardware capabilities,
> limit to
>>>> the values from the capabilities.
>>>>
>>>> And this sets hardware capability values if FIFO sizes are not
> specified
>>>> and removes redundant lines.
>>>
>>> I think you also indeed to explain why (and possibly understand) - if
>>> there are hardware capabilities that describe these parameters - it
> has
>>> been necessary to have them in firmware as well.
>>>
>>> There are two scenarios I can think of why these would be duplicated:
>>>
>>> 1. firmware/platform capabilities are there to correct wrong values
>>> provided by the hardware.
>>> 2. firmware/platform capabilities are there to reduce the parameters
>>> below hardware maximums.
>>>
>>> Which it is affects whether your patch is correct or not, and thus
> needs
>>> to be mentioned.
>>
>> I think scenario 2 applies in this case.
>
> In light of my other reply
> (https://lore.kernel.org/r/Z4_ZilVFKacuAUE8@shell.armlinux.org.uk) I
> don't think either of my two above applies, and the driver is designed
> to allow platform code to override the hardware value, or to provide
> the value if there is no hardware value.
I understand. Especially I realized that I had to care about some hardwares
not having these values.
> My suggestion, therefore, would be (e.g.):
>
> if (priv->dma_cap.rx_fifo_size &&
> priv->plat->rx_fifo_size > priv->dma_cap.rx_fifo_size) {
> dev_warn(priv->device,
> "Rx FIFO size exceeds dma capability (%d)\n",
> priv->plat->rx_fifo_size);
> priv->plat->rx_fifo_size = priv->dma_cap.rx_fifo_size;
> }
>
> if we still want to limit it to the hardware provided capability, where
> that is provided.
Thank you for your suggestion. I also came up with the same code in:
https://lore.kernel.org/all/c2aa354d-1bd5-4fb0-aa8b8-48fcce3c1628@socionext.com/#t
I'll reflect this code to the next.
Thank you,
---
Best Regards
Kunihiko Hayashi
More information about the linux-arm-kernel
mailing list