[PATCH net v2 2/3] net: stmmac: Limit FIFO size by hardware capability

[Kunihiko Hayashi]

Tx/Rx FIFO size is specified by the parameter "{tx,rx}-fifo-depth" from
stmmac_platform layer.

However, these values are constrained by upper limits determined by the
capabilities of each hardware feature. There is a risk that the upper
bits will be truncated due to the calculation, so it's appropriate to
limit them to the upper limit values and display a warning message.

Fixes: e7877f52fd4a ("stmmac: Read tx-fifo-depth and rx-fifo-depth from the devicetree")
Signed-off-by: Kunihiko Hayashi <hayashi.kunihiko at socionext.com>
---
 drivers/net/ethernet/stmicro/stmmac/stmmac_main.c | 13 +++++++++++++
 1 file changed, 13 insertions(+)

diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
index 251a8c15637f..da3316e3e93b 100644
--- a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
+++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
@@ -7245,6 +7245,19 @@ static int stmmac_hw_init(struct stmmac_priv *priv)
 		priv->plat->tx_queues_to_use = priv->dma_cap.number_tx_queues;
 	}
 
+	if (priv->plat->rx_fifo_size > priv->dma_cap.rx_fifo_size) {
+		dev_warn(priv->device,
+			 "Rx FIFO size exceeds dma capability (%d)\n",
+			 priv->plat->rx_fifo_size);
+		priv->plat->rx_fifo_size = priv->dma_cap.rx_fifo_size;
+	}
+	if (priv->plat->tx_fifo_size > priv->dma_cap.tx_fifo_size) {
+		dev_warn(priv->device,
+			 "Tx FIFO size exceeds dma capability (%d)\n",
+			 priv->plat->tx_fifo_size);
+		priv->plat->tx_fifo_size = priv->dma_cap.tx_fifo_size;
+	}
+
 	priv->hw->vlan_fail_q_en =
 		(priv->plat->flags & STMMAC_FLAG_VLAN_FAIL_Q_EN);
 	priv->hw->vlan_fail_q = priv->plat->vlan_fail_q;
-- 
2.25.1