[PATCH 4/5] spi: zynqmp-gqspi: Allow interrupting operations

[Sean Anderson]

On 1/17/25 03:41, Miquel Raynal wrote:
> Hello Sean,
> 
> On 16/01/2025 at 17:55:20 -05, Sean Anderson <sean.anderson at linux.dev> wrote:
> 
>> Some operations (such as reading several megabytes of data from a flash)
>> can take several seconds or more. Users may want to cancel such
>> operations. Allow them to do so now that we have a way to recover.
> 
> I fully agree with the observation, I tried myself interrupting too long
> transfers with another spi controller:
> 
> e0205d6203c2c ("spi: atmel: Prevent false timeouts on long transfers")
> 
> But there were issues reported, so we limited the signals to SIGKILLs:
> 
> 1ca2761a77349 ("spi: atmel: Do not cancel a transfer upon any signal")
> 
> But jffs2 plays with sigkills, so for spi memories it does not work
> well, we had to revert:
> 
> 890188d2d7e4a ("spi: atmel: Prevent spi transfers from being killed")
> 
> Same thing was also observed on Zynq7000:
> 
> 26cfc0dbe43aa ("spi: spi-zynq-qspi: use wait_for_completion_timeout to make zynq_qspi_exec_mem_op not interruptible")
> 
> I would however hint to use a specific helper for deriving your timeouts
> if you play with spi memories, because it is interesting to adapt the
> values nevertheless:
> 
> d8e4ebf870187 ("spi: Create a helper to derive adaptive timeouts")

Hm, ok. I wasn't sure whether this was allowed, but I saw a lot of
interruptable users under drivers/spi.

I guess I'll drop this patch for v2.

--Sean