[PATCH] ARM: dts: ti: davinci: Align GPIO hog name with bindings

[Krzysztof Kozlowski]

Bindings expect GPIO hog names to end with 'hog' suffix, so correct it
to fix dtbs_check warnings like:

  da850-lego-ev3.dtb: batt_volt_en: $nodename:0: 'batt_volt_en' does not match '^.+-hog(-[0-9]+)?$'

Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski at linaro.org>
---
 arch/arm/boot/dts/ti/davinci/da850-lego-ev3.dts | 10 +++++-----
 1 file changed, 5 insertions(+), 5 deletions(-)

diff --git a/arch/arm/boot/dts/ti/davinci/da850-lego-ev3.dts b/arch/arm/boot/dts/ti/davinci/da850-lego-ev3.dts
index 4df10379ff22..173401c58d53 100644
--- a/arch/arm/boot/dts/ti/davinci/da850-lego-ev3.dts
+++ b/arch/arm/boot/dts/ti/davinci/da850-lego-ev3.dts
@@ -412,14 +412,14 @@ &gpio {
 	status = "okay";
 
 	/* Don't pull down battery voltage adc io channel */
-	batt_volt_en {
+	batt-volt-en-hog {
 		gpio-hog;
 		gpios = <6 GPIO_ACTIVE_HIGH>;
 		output-high;
 	};
 
 	/* Don't impede Bluetooth clock signal */
-	bt_clock_en {
+	bt-clock-en-hog {
 		gpio-hog;
 		gpios = <5 GPIO_ACTIVE_HIGH>;
 		input;
@@ -433,19 +433,19 @@ bt_clock_en {
 	 * anything, but they are present in the source code from LEGO.
 	 */
 
-	bt_pic_en {
+	bt-pic-en-hog {
 		gpio-hog;
 		gpios = <51 GPIO_ACTIVE_HIGH>;
 		output-low;
 	};
 
-	bt_pic_rst {
+	bt-pic-rst-hog {
 		gpio-hog;
 		gpios = <78 GPIO_ACTIVE_HIGH>;
 		output-high;
 	};
 
-	bt_pic_cts {
+	bt-pic-cts-hog {
 		gpio-hog;
 		gpios = <87 GPIO_ACTIVE_HIGH>;
 		input;
-- 
2.43.0