[PATCH net-next v3 10/18] net: stmmac: convert to use phy_eee_rx_clock_stop()

[Russell King (Oracle)]

Convert stmmac to use phy_eee_rx_clock_stop() to set the PHY receive
clock stop in LPI setting, rather than calling the legacy
phy_init_eee() function.

Reviewed-by: Andrew Lunn <andrew at lunn.ch>
Signed-off-by: Russell King (Oracle) <rmk+kernel at armlinux.org.uk>
---
 drivers/net/ethernet/stmicro/stmmac/stmmac_main.c | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
index fc80ed101a79..adc51087f2ba 100644
--- a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
+++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
@@ -1077,10 +1077,10 @@ static void stmmac_mac_link_up(struct phylink_config *config,
 
 	stmmac_mac_set(priv, priv->ioaddr, true);
 	if (phy && priv->dma_cap.eee) {
-		priv->eee_active = phy->enable_tx_lpi &&
-			phy_init_eee(phy, !(priv->plat->flags &
-				STMMAC_FLAG_RX_CLK_RUNS_IN_LPI)) >= 0;
+		phy_eee_rx_clock_stop(phy, !(priv->plat->flags &
+					     STMMAC_FLAG_RX_CLK_RUNS_IN_LPI));
 		priv->tx_lpi_timer = phy->eee_cfg.tx_lpi_timer;
+		priv->eee_active = phy->enable_tx_lpi;
 		priv->eee_enabled = stmmac_eee_init(priv);
 		stmmac_set_eee_pls(priv, priv->hw, true);
 	}
-- 
2.30.2