[PATCH] arm64: dts: ti: k3-am625-beagleplay: fix DP83TD510E reset time
Francesco Valla
francesco at valla.it
Sun Jan 5 08:26:30 PST 2025
The reset deassert time for the DP83TD510E is incorrectly set to
60000us, while the datasheet states that the minimum time required
after an hard reset is 30us (while 60ms is the time required for the
Power-On Reset after supply stabilization). The error probably arose
from the two timings being indicated by the same symbol (T2).
Lower the required time to 35us, aligning it to the value required for
the PHY to complete the reset AND to be able to accept the RMII master
clock. This saves ~60ms on boot if the MDIO driver is built-in.
Signed-off-by: Francesco Valla <francesco at valla.it>
---
arch/arm64/boot/dts/ti/k3-am625-beagleplay.dts | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/arch/arm64/boot/dts/ti/k3-am625-beagleplay.dts b/arch/arm64/boot/dts/ti/k3-am625-beagleplay.dts
index ee96f4f6deb0..75c80290b12a 100644
--- a/arch/arm64/boot/dts/ti/k3-am625-beagleplay.dts
+++ b/arch/arm64/boot/dts/ti/k3-am625-beagleplay.dts
@@ -610,7 +610,7 @@ cpsw3g_phy1: ethernet-phy at 1 {
reg = <1>;
reset-gpios = <&main_gpio1 5 GPIO_ACTIVE_LOW>;
reset-assert-us = <25>;
- reset-deassert-us = <60000>; /* T2 */
+ reset-deassert-us = <35>;
};
};
--
2.47.1
More information about the linux-arm-kernel
mailing list