[PATCH 1/3] i2c: davinci: kill platform data
Andi Shyti
andi.shyti at kernel.org
Fri Jan 3 16:02:51 PST 2025
Hi Bartosz,
On Thu, Jan 02, 2025 at 01:44:10PM +0100, Bartosz Golaszewski wrote:
> On Fri, Dec 27, 2024 at 12:41 AM Andi Shyti <andi.shyti at kernel.org> wrote:
> >
> > Hi Bartosz,
> >
> > ...
> >
> > > struct davinci_i2c_dev {
> > > struct device *dev;
> > > void __iomem *base;
> > > @@ -132,13 +133,10 @@ struct davinci_i2c_dev {
> > > #ifdef CONFIG_CPU_FREQ
> > > struct notifier_block freq_transition;
> > > #endif
> > > - struct davinci_i2c_platform_data *pdata;
> > > -};
> > > -
> > > -/* default platform data to use if not supplied in the platform_device */
> > > -static struct davinci_i2c_platform_data davinci_i2c_platform_data_default = {
> > > - .bus_freq = 100,
> > > - .bus_delay = 0,
> >
> > what happened to bus_delay?
> >
>
> bus_delay is not set by means other than platform data and it defaults
> to 0 so it's safe to just remove it.
yes, but how is it related to this patch? Can we put it on a
different patch?
Thanks,
Andi
> > ...
> >
> > > + /* standard bus frequency (kHz) */
> > > + unsigned int bus_freq;
> > > + /* Chip has a ICPFUNC register */
> > > + bool has_pfunc;
> > > };
> >
> > > -static struct i2c_bus_recovery_info davinci_i2c_gpio_recovery_info = {
> > > - .recover_bus = i2c_generic_scl_recovery,
> > > - .prepare_recovery = davinci_i2c_prepare_recovery,
> > > - .unprepare_recovery = davinci_i2c_unprepare_recovery,
> > > -};
> > > -
> >
> > what happened to the gpio_recovery_info?
> >
>
> Similar story: it's only ever used if there's a pdata-provided
> recovery GPIO line set but nobody does it anymore.
>
> Bartosz
More information about the linux-arm-kernel
mailing list