[PATCH v3 0/4] Add support for NetCube Systems Kumquat
Lukas Schmid
lukas.schmid at netcube.li
Fri Jan 3 12:45:16 PST 2025
This series adds dt-bindings and dts for the NetCube Systems Kumquat board.
Changes in v2:
Fix the devicetrees according to the "dt-schema" and "make dtbs_check W=1"
Fix the License of the devicetree as requested
Create a cover letter for the patch series
Changes in v3:
Disable rtc inside the SoC again, as the rtc does not work
Add the gpio-reserved-ranges property to the pinctrl bindings
Reorder the nodes in the devicetree to match the order of the nodes in the
sun8i-v3s.dtsi file
Signed-off-by: Lukas Schmid <lukas.schmid at netcube.li>
---
Lukas Schmid (4):
dt-bindings: vendor-prefixes: Add NetCube Systems Austria name
dt-bindings: arm: sunxi: Add NetCube Systems Kumquat board
dt-bindings: pinctrl: sunxi: Add gpio-reserved-ranges property
ARM: dts: sunxi: add support for NetCube Systems Kumquat
.../devicetree/bindings/arm/sunxi.yaml | 5 +
.../pinctrl/allwinner,sun4i-a10-pinctrl.yaml | 5 +
.../devicetree/bindings/vendor-prefixes.yaml | 2 +
arch/arm/boot/dts/allwinner/Makefile | 2 +
.../allwinner/sun8i-v3s-netcube-kumquat.dts | 290 ++++++++++++++++++
arch/arm/boot/dts/allwinner/sun8i-v3s.dtsi | 6 +
6 files changed, 310 insertions(+)
create mode 100644 arch/arm/boot/dts/allwinner/sun8i-v3s-netcube-kumquat.dts
--
2.47.1
More information about the linux-arm-kernel
mailing list