[PATCH 1/1] soc: ti: PRUSS OCP configuration

[MD Danish Anwar]

On 23/12/24 7:25 pm, Basharath Hussain Khaja wrote:
> From: Roger Quadros <rogerq at ti.com>
> 
> Updates OCP master port configuration to enable memory access outside
> of the PRU-ICSS subsystem.
> 
> This set of changes configures PRUSS_SYSCFG.STANDBY_INIT bit either
> to enable or disable the OCP master ports (applicable only on SoCs
> using OCP interconnect like the OMAP family).
> 
> Signed-off-by: Roger Quadros <rogerq at ti.com>
> Signed-off-by: Andrew F. Davis <afd at ti.com>
> Signed-off-by: Parvathi Pudi <parvathi at couthit.com>
> Signed-off-by: Basharath Hussain Khaja <basharath at couthit.com>

The patch LGTM however it doesn't apply cleanly on branch
ti-drivers-soc-next on [1]

This applies cleanly on latest linux-next but not on [1] where Nishant
will eventually apply the patches.

Applying: soc: ti: PRUSS OCP configuration
Patch failed at 0001 soc: ti: PRUSS OCP configuration
When you have resolved this problem, run "git am --continue".
If you prefer to skip this patch, run "git am --skip" instead.
To restore the original branch and stop patching, run "git am --abort".
error: patch failed: include/linux/pruss_driver.h:172
error: include/linux/pruss_driver.h: patch does not apply
hint: Use 'git am --show-current-patch=diff' to see the failed patch

Please re-base the patch on [1] and re-send.

[1] https://git.kernel.org/pub/scm/linux/kernel/git/ti/linux.git

-- 
Thanks and Regards,
Danish