[PATCH v11 2/2] arm64: dts: qcom: qcs6490-rb3gen2-vision-mezzanine: Add vision mezzanine
Konrad Dybcio
konrad.dybcio at oss.qualcomm.com
Sat Feb 1 08:26:56 PST 2025
On 21.01.2025 1:50 PM, Vikram Sharma wrote:
> The Vision Mezzanine for the RB3 ships with an imx577 camera sensor.
> Enable the IMX577 on the vision mezzanine.
>
> An example media-ctl pipeline for the imx577 is:
>
> media-ctl --reset
> media-ctl -v -V '"imx577 '17-001a'":0[fmt:SRGGB10/4056x3040 field:none]'
> media-ctl -V '"msm_csiphy3":0[fmt:SRGGB10/4056x3040]'
> media-ctl -V '"msm_csid0":0[fmt:SRGGB10/4056x3040]'
> media-ctl -V '"msm_vfe0_rdi0":0[fmt:SRGGB10/4056x3040]'
> media-ctl -l '"msm_csiphy3":1->"msm_csid0":0[1]'
> media-ctl -l '"msm_csid0":1->"msm_vfe0_rdi0":0[1]'
>
> yavta -B capture-mplane -c -I -n 5 -f SRGGB10P -s 4056x3040 -F /dev/video0
>
> Signed-off-by: Hariram Purushothaman <quic_hariramp at quicinc.com>
> Signed-off-by: Vikram Sharma <quic_vikramsa at quicinc.com>
> Signed-off-by: Trishansh Bhardwaj <quic_tbhardwa at quicinc.com>
> Reviewed-by: Bryan O'Donoghue <bryan.odonoghue at linaro.org>
> ---
> +&tlmm {
> + cam2_default: cam2-default-state {
> + mclk-pins {
> + pins = "gpio67";
> + function = "cam_mclk";
> + drive-strength = <2>;
> + bias-disable;
> + };
If you don't plan on adding more pins there, drop mclk-pins{} and put the
properties directly under the cam2-default-state node, similarly below
with that
Reviewed-by: Konrad Dybcio <konrad.dybcio at linaro.org>
Konrad
> + };
> +
> + cam2_suspend: cam2-suspend-state {
> + mclk-pins {
> + pins = "gpio67";
> + function = "cam_mclk";
> + drive-strength = <2>;
> + bias-pull-down;
> + };
> + };
> +};
More information about the linux-arm-kernel
mailing list