[PATCH 6/6] scsi: ufs: exynos: put ufs device in reset on .exit() and .suspend()
Peter Griffin
peter.griffin at linaro.org
Wed Feb 26 14:04:14 PST 2025
GPIO_OUT[0] is connected to the reset pin of embedded UFS device.
Before powering off the phy assert the reset signal.
Signed-off-by: Peter Griffin <peter.griffin at linaro.org>
---
drivers/ufs/host/ufs-exynos.c | 3 +++
1 file changed, 3 insertions(+)
diff --git a/drivers/ufs/host/ufs-exynos.c b/drivers/ufs/host/ufs-exynos.c
index 4c3e03a3b8d9..64e2bf924213 100644
--- a/drivers/ufs/host/ufs-exynos.c
+++ b/drivers/ufs/host/ufs-exynos.c
@@ -1517,6 +1517,7 @@ static void exynos_ufs_exit(struct ufs_hba *hba)
{
struct exynos_ufs *ufs = ufshcd_get_variant(hba);
+ hci_writel(ufs, 0 << 0, HCI_GPIO_OUT);
phy_power_off(ufs->phy);
phy_exit(ufs->phy);
}
@@ -1700,6 +1701,8 @@ static int exynos_ufs_suspend(struct ufs_hba *hba, enum ufs_pm_op pm_op,
if (status == PRE_CHANGE)
return 0;
+ hci_writel(ufs, 0 << 0, HCI_GPIO_OUT);
+
if (!ufshcd_is_link_active(hba))
phy_power_off(ufs->phy);
--
2.48.1.658.g4767266eb4-goog
More information about the linux-arm-kernel
mailing list