[PATCH 3/6] scsi: ufs: exynos: ensure consistent phy reference counts

[Peter Griffin]

ufshcd_link_startup() can call ufshcd_vops_link_startup_notify()
multiple times when retrying. This causes the phy reference count
to keep increasing and the phy to not properly re-initialize.

If the phy has already been previously powered on, first issue a
phy_power_off() and phy_exit(), before re-initializing and powering
on again.

Signed-off-by: Peter Griffin <peter.griffin at linaro.org>
---
 drivers/ufs/host/ufs-exynos.c | 6 ++++++
 1 file changed, 6 insertions(+)

diff --git a/drivers/ufs/host/ufs-exynos.c b/drivers/ufs/host/ufs-exynos.c
index a00256ede659..943cea569f66 100644
--- a/drivers/ufs/host/ufs-exynos.c
+++ b/drivers/ufs/host/ufs-exynos.c
@@ -962,6 +962,12 @@ static int exynos_ufs_phy_init(struct exynos_ufs *ufs)
 	}
 
 	phy_set_bus_width(generic_phy, ufs->avail_ln_rx);
+
+	if (generic_phy->power_count) {
+		phy_power_off(generic_phy);
+		phy_exit(generic_phy);
+	}
+
 	ret = phy_init(generic_phy);
 	if (ret) {
 		dev_err(hba->dev, "%s: phy init failed, ret = %d\n",
-- 
2.48.1.658.g4767266eb4-goog