[PATCH net-next v4 2/4] stmmac: loongson: Remove surplus loop

[Philipp Stanner]

loongson_dwmac_probe() contains a loop which doesn't have an effect,
because it tries to call pcim_iomap_regions() with the same parameters
several times. The break statement at the loop's end furthermore ensures
that the loop only runs once anyways.

Remove the surplus loop.

Signed-off-by: Philipp Stanner <phasta at kernel.org>
Reviewed-by: Andrew Lunn <andrew at lunn.ch>
Reviewed-by: Yanteng Si <si.yanteng at linux.dev>
Reviewed-by: Huacai Chen <chenhuacai at loongson.cn>
Tested-by: Henry Chen <chenx97 at aosc.io>
---
 .../net/ethernet/stmicro/stmmac/dwmac-loongson.c    | 13 ++++---------
 1 file changed, 4 insertions(+), 9 deletions(-)

diff --git a/drivers/net/ethernet/stmicro/stmmac/dwmac-loongson.c b/drivers/net/ethernet/stmicro/stmmac/dwmac-loongson.c
index 73a6715a93e6..e2959ac5c1ca 100644
--- a/drivers/net/ethernet/stmicro/stmmac/dwmac-loongson.c
+++ b/drivers/net/ethernet/stmicro/stmmac/dwmac-loongson.c
@@ -524,7 +524,7 @@ static int loongson_dwmac_probe(struct pci_dev *pdev, const struct pci_device_id
 	struct stmmac_pci_info *info;
 	struct stmmac_resources res;
 	struct loongson_data *ld;
-	int ret, i;
+	int ret;
 
 	plat = devm_kzalloc(&pdev->dev, sizeof(*plat), GFP_KERNEL);
 	if (!plat)
@@ -554,14 +554,9 @@ static int loongson_dwmac_probe(struct pci_dev *pdev, const struct pci_device_id
 	pci_set_master(pdev);
 
 	/* Get the base address of device */
-	for (i = 0; i < PCI_STD_NUM_BARS; i++) {
-		if (pci_resource_len(pdev, i) == 0)
-			continue;
-		ret = pcim_iomap_regions(pdev, BIT(0), DRIVER_NAME);
-		if (ret)
-			goto err_disable_device;
-		break;
-	}
+	ret = pcim_iomap_regions(pdev, BIT(0), DRIVER_NAME);
+	if (ret)
+		goto err_disable_device;
 
 	memset(&res, 0, sizeof(res));
 	res.addr = pcim_iomap_table(pdev)[0];
-- 
2.48.1