[EXTERNAL] Re: [PATCH v2 2/4] dt-bindings: cp110: Document the reset controller

[Wilson Ding]

> -----Original Message-----
> From: Krzysztof Kozlowski <krzk at kernel.org>
> Sent: Friday, February 21, 2025 12:47 AM
> To: Wilson Ding <dingwei at marvell.com>
> Cc: linux-kernel at vger.kernel.org; devicetree at vger.kernel.org; linux-arm-
> kernel at lists.infradead.org; andrew at lunn.ch; gregory.clement at bootlin.com;
> sebastian.hesselbarth at gmail.com; robh at kernel.org; krzk+dt at kernel.org;
> conor+dt at kernel.org; p.zabel at pengutronix.de; Sanghoon Lee
> <salee at marvell.com>; Geethasowjanya Akula <gakula at marvell.com>
> Subject: [EXTERNAL] Re: [PATCH v2 2/4] dt-bindings: cp110: Document the
> reset controller
> 
> On Thu, Feb 20, 2025 at 03: 25: 25PM -0800, Wilson Ding wrote: > Add reset-
> controller sub-node into the system controller node, and > document the
> supported reset lines. > > Signed-off-by: Wilson Ding
> <dingwei@ marvell. com> > 
> On Thu, Feb 20, 2025 at 03:25:25PM -0800, Wilson Ding wrote:
> > Add reset-controller sub-node into the system controller node, and
> > document the supported reset lines.
> >
> > Signed-off-by: Wilson Ding <dingwei at marvell.com>
> > ---
> >  .../arm/marvell/cp110-system-controller.txt   | 43 +++++++++++++++++++
> 
> NAK.
> 
> You already got feedback that TXT bindings are not accepted.
> 

I am not trying to use this TXT for dt-binding. But as you can see this file
describes all the sub-nodes details, such as mpps, clocks information. So
that I add the reset line info here. If this is not the right place, where shall
I put this information. I wonder if you are asking to convert this txt into
yaml.

> Best regards,
> Krzysztof