[PATCH v5] arm64: dts: mediatek: mt8395-genio-1200-evk: add support for TCPC port
Rob Herring (Arm)
robh at kernel.org
Fri Feb 21 10:11:04 PST 2025
On Fri, 21 Feb 2025 22:49:41 +0800, Macpaul Lin wrote:
> From: Fabien Parent <fparent at baylibre.com>
>
> Enable USB Type-C support on MediaTek MT8395 Genio 1200 EVK by adding
> configuration for TCPC Port, USB-C connector, MUX IT5205 and related
> settings.
>
> Configure dual role switch capability, set up PD (Power Delivery) profiles,
> and establish endpoints for SS (SuperSpeed) and HS (HighSpeed) USB.
>
> Update pinctrl configurations for U3 P0 VBus default pins and set dr_mode
> to "otg" for OTG (On-The-Go) mode operation.
>
> Add ITE IT5205 (TYPEC MUX) under I2C2 bus and configure its properties;
> also add references and configurations to 'typec-mux' node.
>
> Signed-off-by: Fabien Parent <fparent at baylibre.com>
> Signed-off-by: Yow-Shin Liou <yow-shin.liou at mediatek.com>
> Signed-off-by: Simon Sun <simon.sun at yunjingtech.com>
> Signed-off-by: Macpaul Lin <macpaul.lin at mediatek.com>
> ---
> .../dts/mediatek/mt8395-genio-1200-evk.dts | 100 ++++++++++++++++++
> 1 file changed, 100 insertions(+)
>
> Changes for v2:
> - Drop the no need '1/2' DT Schema update patch in the 1st version.
> - Fix indent for 'ports' node, it should under the 'connector' node.
> - Correct the index for 'port at 0' and 'port at 1' node.
>
> Changes for v3:
> - Correct the order between new added nodes.
>
> Changes for v4:
> - Reorder for property 'op-sink-microwatt'.
> - Fix indentation for 'source-pdos' and 'sink-pdos' nodes.
> - Correct node 'pin-cmd-dat' with 'pins-vbus'.
> - Add both Highspeed and Superspeed ports to ssusb0 port.
> - Set 'role-switch-default-mode' = "peripheral" for ssusb0 port.
> - Rename endpoint of USB data port to 'mtu3_hs0_role_sw' and
> 'mtu3_ss0_role_sw'.
> - Drop it5205fn phandle for node typec-mux at 48.
> - Reorder properties of typec-mux at 48
> - Add "Reviewed-by:" tag. Thanks!
>
> Changes for v5:
> - Squash two patches into one patch and refine commit messages:
> suggested by reviewer.
> - Drop 'role-switch-default-mode'
> - Add altmodes settings
> - Drop 'Reviewed-by:' tag since the two sub patches has been combined
> into a new patch.
>
My bot found new DTB warnings on the .dts files added or changed in this
series.
Some warnings may be from an existing SoC .dtsi. Or perhaps the warnings
are fixed by another series. Ultimately, it is up to the platform
maintainer whether these warnings are acceptable or not. No need to reply
unless the platform maintainer has comments.
If you already ran DT checks and didn't see these error(s), then
make sure dt-schema is up to date:
pip3 install dtschema --upgrade
New warnings running 'make CHECK_DTBS=y for arch/arm64/boot/dts/mediatek/' for 20250221144941.2844333-1-macpaul.lin at mediatek.com:
arch/arm64/boot/dts/mediatek/mt8395-genio-1200-evk.dtb: usb at 11201000: 'ports' does not match any of the regexes: '^usb@[0-9a-f]+$', 'pinctrl-[0-9]+'
from schema $id: http://devicetree.org/schemas/usb/mediatek,mtu3.yaml#
More information about the linux-arm-kernel
mailing list