[PATCH v2 2/4] dt-bindings: cp110: Document the reset controller

Wilson Ding dingwei at marvell.com
Thu Feb 20 15:25:25 PST 2025


Add reset-controller sub-node into the system controller node, and
document the supported reset lines.

Signed-off-by: Wilson Ding <dingwei at marvell.com>
---
 .../arm/marvell/cp110-system-controller.txt   | 43 +++++++++++++++++++
 1 file changed, 43 insertions(+)

diff --git a/Documentation/devicetree/bindings/arm/marvell/cp110-system-controller.txt b/Documentation/devicetree/bindings/arm/marvell/cp110-system-controller.txt
index 9d5d70c98058..5e2c2f2b147c 100644
--- a/Documentation/devicetree/bindings/arm/marvell/cp110-system-controller.txt
+++ b/Documentation/devicetree/bindings/arm/marvell/cp110-system-controller.txt
@@ -164,6 +164,43 @@ Required properties:
 
 - offset: offset address inside the syscon block
 
+Reset Controller:
+-----------------
+
+For common binding part and usage, refer to
+Documentation/devicetree/bindings/reset/marvell,armada8k-reset.yaml.
+
+The Device Tree node representing this System Controller 0 provides a
+number of reset lines:
+
+The following reset lines are available:
+
+-  0: Audio Software RESETn
+-  1: TDM Software RESETn
+-  2: Interrupt controller unit Software RESETn
+-  3: Packet processor Software RESETn
+-  4: SDIO Software RESETn
+-  7: XOR-1 engine Software RESETn
+-  8: XOR-0 engine Software RESETn
+- 11: PCIe-0 Gen.3 x1 Software RESETn
+- 12: PCIe-1 Gen.3 x1 Software RESETn
+- 13: PCIe Gen.3 x4 Software RESETn
+- 15: SATA port 0 and port 1 Software RESETn
+- 22: USB3 Host 0 Software RESETn
+- 23: USB3 Host 1 Software RESETn
+- 24: USB3 Device Software RESETn
+- 25: EIP150F Software RESETn
+- 26: EIP197 Software RESETn
+- 29: MSS Software RESETn
+
+Required properties:
+
+ - compatible: "marvell,armada8k-reset"
+
+ - offset: offset address inside the syscon block
+
+ - #reset-cells: must be set to 1
+
 Example:
 
 CP110_LABEL(syscon0): system-controller at 440000 {
@@ -188,6 +225,12 @@ CP110_LABEL(syscon0): system-controller at 440000 {
 		gpio-ranges = <&CP110_LABEL(pinctrl) 0 0 32>;
 	};
 
+	CP11X_LABEL(unit_swrst): reset-controller at 268 {
+		compatible = "marvell,armada8k-reset";
+		offset = <0x268>;
+		#reset-cells = <1>;
+	};
+
 };
 
 SYSTEM CONTROLLER 1
-- 
2.43.0




More information about the linux-arm-kernel mailing list