[PATCH net-next] net: stmmac: print stmmac_init_dma_engine() errors using netdev_err()

[Russell King (Oracle)]

stmmac_init_dma_engine() uses dev_err() which leads to errors being
reported as e.g:

dwc-eth-dwmac 2490000.ethernet: Failed to reset the dma
dwc-eth-dwmac 2490000.ethernet eth0: stmmac_hw_setup: DMA engine initialization failed

stmmac_init_dma_engine() is only called from stmmac_hw_setup() which
itself uses netdev_err(), and we will have a net_device setup. So,
change the dev_err() to netdev_err() to give consistent error
messages.

Signed-off-by: Russell King (Oracle) <rmk+kernel at armlinux.org.uk>
---
 drivers/net/ethernet/stmicro/stmmac/stmmac_main.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
index 4d542f482ecb..218ecc945e9e 100644
--- a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
+++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
@@ -3034,7 +3034,7 @@ static int stmmac_init_dma_engine(struct stmmac_priv *priv)
 	int ret = 0;
 
 	if (!priv->plat->dma_cfg || !priv->plat->dma_cfg->pbl) {
-		dev_err(priv->device, "Invalid DMA configuration\n");
+		netdev_err(priv->dev, "Invalid DMA configuration\n");
 		return -EINVAL;
 	}
 
@@ -3043,7 +3043,7 @@ static int stmmac_init_dma_engine(struct stmmac_priv *priv)
 
 	ret = stmmac_reset(priv, priv->ioaddr);
 	if (ret) {
-		dev_err(priv->device, "Failed to reset the dma\n");
+		netdev_err(priv->dev, "Failed to reset the dma\n");
 		return ret;
 	}
 
-- 
2.30.2