[PATCH v1] arm64: dts: freescale: imx8mm-verdin: Remove LVDS panel and backlight

[Francesco Dolcini]

From: Francesco Dolcini <francesco.dolcini at toradex.com>

Remove LVDS panel and backlight nodes from the Verdin iMX8M Mini SoM
dtsi file, those two hardware components are not part of the SoM,
therefore they should not be present in this file.

This is solving a dtb checker warning about panel-lvds compatible.

Signed-off-by: Francesco Dolcini <francesco.dolcini at toradex.com>
---
 .../boot/dts/freescale/imx8mm-verdin.dtsi     | 21 -------------------
 1 file changed, 21 deletions(-)

diff --git a/arch/arm64/boot/dts/freescale/imx8mm-verdin.dtsi b/arch/arm64/boot/dts/freescale/imx8mm-verdin.dtsi
index c528594ac442..7251ad3a0017 100644
--- a/arch/arm64/boot/dts/freescale/imx8mm-verdin.dtsi
+++ b/arch/arm64/boot/dts/freescale/imx8mm-verdin.dtsi
@@ -18,20 +18,6 @@ aliases {
 		rtc1 = &snvs_rtc;
 	};
 
-	backlight: backlight {
-		compatible = "pwm-backlight";
-		brightness-levels = <0 45 63 88 119 158 203 255>;
-		default-brightness-level = <4>;
-		/* Verdin I2S_2_D_OUT (DSI_1_BKL_EN/DSI_1_BKL_EN_LVDS, SODIMM 46) */
-		enable-gpios = <&gpio3 24 GPIO_ACTIVE_HIGH>;
-		pinctrl-names = "default";
-		pinctrl-0 = <&pinctrl_i2s_2_d_out_dsi_1_bkl_en>;
-		power-supply = <&reg_3p3v>;
-		/* Verdin PWM_3_DSI/PWM_3_DSI_LVDS (SODIMM 19) */
-		pwms = <&pwm1 0 6666667 PWM_POLARITY_INVERTED>;
-		status = "disabled";
-	};
-
 	/* Fixed clock dedicated to SPI CAN controller */
 	clk40m: oscillator {
 		compatible = "fixed-clock";
@@ -66,13 +52,6 @@ hdmi_connector: hdmi-connector {
 		status = "disabled";
 	};
 
-	panel_lvds: panel-lvds {
-		compatible = "panel-lvds";
-		backlight = <&backlight>;
-		data-mapping = "vesa-24";
-		status = "disabled";
-	};
-
 	/* Carrier Board Supplies */
 	reg_1p8v: regulator-1p8v {
 		compatible = "regulator-fixed";
-- 
2.39.5