[PATCH net-next v4 13/15] net: phy: dp83822: Add SFP support through the phy_port interface

Maxime Chevallier maxime.chevallier at bootlin.com
Thu Feb 13 02:16:01 PST 2025


The DP83822 can support 100BaseFX. This mode was only accessible through
custom DT properties, but there also exist SFP modules that support
these modes. As this only requires setting the relevant supported
interface in the driver, expose the port capability with the new
phy_port API, allowing SFP support.

Signed-off-by: Maxime Chevallier <maxime.chevallier at bootlin.com>
---
V4: no changes

 drivers/net/phy/dp83822.c | 7 +++++++
 1 file changed, 7 insertions(+)

diff --git a/drivers/net/phy/dp83822.c b/drivers/net/phy/dp83822.c
index af535b0a3914..873ba467cd57 100644
--- a/drivers/net/phy/dp83822.c
+++ b/drivers/net/phy/dp83822.c
@@ -908,6 +908,13 @@ static int dp83822_attach_port(struct phy_device *phydev, struct phy_port *port)
 		}
 	}
 
+	/* If attached from SFP, is_serdes is set, but not the mediums. */
+	if (port->is_serdes)
+		dp83822->fx_enabled = true;
+
+	if (dp83822->fx_enabled)
+		__set_bit(PHY_INTERFACE_MODE_100BASEFX, interfaces);
+
 	return 0;
 }
 
-- 
2.48.1




More information about the linux-arm-kernel mailing list